8T 2.0
05-22-2009 | 09:16 PM
#2671
Tech Fanatic
iTrader: (2)
Joined: Feb 2008
Posts: 778
I just put a 750 motor in my losi box. Unhooked the other 2 and took the one on the right out. Removed the shield piece off the one on the left to gain a little more room. Drilled out the top slider slot for the bigger screw to go into the motor since they are bigger screws that bolt them in. Drilled another hole through the motor plate and through the back of the motor, It will not be adjustable and with it all the way against that side of the box the belt is tight enough to stay on good. Wired it up for just the 1 big motor and left the other one there just to use the gear. Wired it all back up and Poof it started my truggy. I don't know how long this will last and I dont care if it lasts that long. I just need it to work until my new box gets here.
05-22-2009 | 09:23 PM
#2672
05-22-2009 | 09:59 PM
#2673
(with the truggy that is)
05-23-2009 | 01:38 PM
#2677
Tech Adept
Joined: May 2009
Posts: 143
From: Bremerhaven, Germany
ok..maybe im lil dumb or my english in not good enough...
I tried to copy Drakes setup...most things is no problem..but where and how to measure the droop? thats 110mm front and 130mm in the rear but i dont know from what to what point i habe to measure it
I tried to copy Drakes setup...most things is no problem..but where and how to measure the droop? thats 110mm front and 130mm in the rear but i dont know from what to what point i habe to measure it
05-23-2009 | 01:39 PM
#2678
get some calipers, and measure from the center of the top and bottom shock screw.
05-23-2009 | 05:35 PM
#2682
I was at a Memorial Day Shoot out today and I had a shock shaft come apart. The screw backed out that holds the piston on it killed my 2nd qual. Whoever built these Losi trucks needs some lessons in quality control. I have never had so many screws back out of a roller before. I think Losi needs to offer the truck as a kit so we can build it right. Ohh well this truck still kicks a$$.
05-23-2009 | 09:58 PM
#2683
I was at a Memorial Day Shoot out today and I had a shock shaft come apart. The screw backed out that holds the piston on it killed my 2nd qual. Whoever built these Losi trucks needs some lessons in quality control. I have never had so many screws back out of a roller before. I think Losi needs to offer the truck as a kit so we can build it right. Ohh well this truck still kicks a$$.
05-23-2009 | 10:03 PM
#2684
Back tomorrow yes .The turnout was about 1/2 of what they expected. 60-70 showed up. It was dusty really really dusty.
05-23-2009 | 11:34 PM
#2685
hey guys. i ran my 2.0 today for the first time since nitro challenge. it ran great as far as the truck goes. had a little cluch problem but i have that fixed already. the only issue i have is i put the 1.0 servo saver spring on but i thinks it to loose. how do i gauge this? i can move the wheels a little side to side with no force but i can turn the wheels ALL the way side to side if i try. i tried my dads buggy and my 2.0 buggy and all are the same way and i havent touched my 2.0 buggy spring