carpet droop 4 front and rear
I measure at the end of the lower arm

i put my car on 10mm blocks and measure over ride height. We have a tight indoor track and i was trying some different things i was running 3mm over rh in the front and 2 over rh in the rear.

nocife was that a pm? I didnt get one, so maybe try again

PM=private messages

Looks like they are available now

http://www.wolfhobbies.com/Products-...ies_Parts.html

Trans Am 4mm over ride height front and rear
Mod foam touring 2mm front, 3mm rear

I measure at the end of the arms also when the car is on blocks.

My hard drive crashed so I'm still rebuilding everything. I'm hoping to have set up sheets by the end of the week or early next.

Marcos, are you using warmers on asphalt or just tire compound?

Socko

I havent used tire warmers in over a year, I clean the tires with WD-40 then I wait a few minutes then apply buggy grip , then let it dry. The tires have excellent grip from start to finish, when I use SXT or Tire Tweek the tires get better towards the end of the run, I had better results with the wd40/buggy grip combo.

Here is my car for this weekend state race

wow...did you let weezy cut out those wheelewells...just kidding weezy...well maybe...so any word on the hubs...

they are a little rough aren't they?

good luck for this week marcos

thanks Olivier

Goodluck at this weekends race.

thanks!

marcos just knows whats up, wheel wells are supposed to be square. Its called a "SPEED SECRET" for a reason. hahaha good luck marcos.

what are you running for speedo battery and motor?
i just got my tekin in the mail today so i will see how that works tomorrow night

right now I'm running LRP TC spec, Speedpassion motors and Core RC battery.