cheers guys will give it a go

exactly!

Yo Joe how ya going, you finally wore out my Kickass worlds evo 11 engine, it will cost you more to reuild it than it cost you new, she was preety quick ah??, lay her to rest now.
Find an cheap evo111 and ill kickass it for you mates rates, im getting bored in my retirement.

Cheers
Alex.K

Retirement?

i think the bright coloured shirts he started wearing made him go blind

There's nothing wrong with Alex K's eyesight

Iv'e got just the motor for you to waive your magic wand over!
I'll help keep you from boredom!
Don't forget to let me know if you want to make a guest appearance!
I'll even lend you one of my Mugen shirts!

Hey guys how can you tell if your rod or crank is no good? Got an evo3 and just replaced my piston& slv. when I put the conrod on the crank pin I noticed there were some play. Running on a tight budget so I just need the part to get my evo3 singing again. Any help would be appreciated. Thanks

there is normally a tiny bit of play.

get a set of calipers and measure your crank pin, make sure it is 'round' if this has warn oval in shape then you could have some problems

Checked my crank with the calipers & got 2 diff. # so I guess it's out of round. Thanks for the help.

You were so right. I ran the STI with the 2611 and Kyosho 2D clutch (w/4 weights) and the car was just screaming. It was so much faster today than it ever has been.

I found the same thing out this weekend.

wish i had that pipe
anyone know where i can get one
i like this motor as a backup to my ninja.
and sometimes i run it first
there my 2 fav motor's. 2611

Try Murnan's.

I just realized that I have a tear in the boot on the carb, do they sell a replacement or do I have to get a new carb.