15LikesRayaracing sleeve resizing and tooling
11-27-2017 | 05:54 AM
#1336
Tech Regular
Joined: May 2009
Posts: 312
From: SoCal
Ray you've got email 
01-27-2018 | 09:28 AM
#1337
Tech Fanatic
iTrader: (23)
Joined: Nov 2002
Posts: 833
From: 4373 Creek Road Chaffee,NY 14030 USA (716)783-5198
Piston&sleeve reconditioning resizing - Race Ready
Eduardo (Florida) serviced and return shipped this morning. Tuesday expected delivery. If the COLD weather didn't break, as it did , I would have hopped on a plane and personally delivers package...it was cold here in Buffalo New York.
Thanks!
Ray
Thanks!
Ray
09-09-2018 | 02:20 PM
#1346
Tech Fanatic
iTrader: (23)
Joined: Nov 2002
Posts: 833
From: 4373 Creek Road Chaffee,NY 14030 USA (716)783-5198
Surface finish damage
Hi Speedworks,
surface finish conditions are equally important as the pinch itself. The scoring on sleeve liner you describe may not easily hone put, resulting a sealing loss . depends on the damage.....you can ship the piston and set an I will let you know after iinspection.
Ray
surface finish conditions are equally important as the pinch itself. The scoring on sleeve liner you describe may not easily hone put, resulting a sealing loss . depends on the damage.....you can ship the piston and set an I will let you know after iinspection.
Ray
09-09-2018 | 05:54 PM
#1347
Tech Adept
iTrader: (3)
Joined: Jul 2009
Posts: 232
From: Florida
Hi Speedworks,
surface finish conditions are equally important as the pinch itself. The scoring on sleeve liner you describe may not easily hone put, resulting a sealing loss . depends on the damage.....you can ship the piston and set an I will let you know after iinspection.
Ray
surface finish conditions are equally important as the pinch itself. The scoring on sleeve liner you describe may not easily hone put, resulting a sealing loss . depends on the damage.....you can ship the piston and set an I will let you know after iinspection.
Ray
09-22-2018 | 08:35 AM
#1348
Tech Addict
Joined: Jun 2015
Posts: 746
Ray,
Here are a couple pictures of an O.S. .30VG set.
Do you think this set is worth sending in? The gouge in the sleeve can be felt with your finger. What worries me is the spec of what appears to be brass showing through. Thanks.
Here are a couple pictures of an O.S. .30VG set.
Do you think this set is worth sending in? The gouge in the sleeve can be felt with your finger. What worries me is the spec of what appears to be brass showing through. Thanks.
09-22-2018 | 09:35 AM
#1349
Tech Adept
iTrader: (7)
Joined: Jan 2018
Posts: 121
I wa going to ask a similar question as above. When I pulled my motor for cleaning I noticed a sngle scratch on the skirt on the rear port side it does go up to the carbon line but not all the way up motor still ran fine before being pull. Is it worth being pinched? It’s has about 5 gallons now it’s a b2101