Was using Paragon FXII. I like Trinity Red Dot better.

Yes

Hey folks
I've picked up an Exotek P-Zero but peeling off the masking leaves a really nasty residue! How are you guys cleaning that crap up?

P Zero worked great this weekend!!

I didn't have this problem with my P-Zero, but in the past I've always used WD40 to remove nasty residue.

By the way, here is a simple paint job on a P-Zero. Car worked great this last weekend.

Anyone know where I can get the p zero body

Go-gone works very well

Contact them to inquire about stock.

P-ZERO GT, clear body lexan w/ wing - Exotek Racing

Anyone using the Protoform Pfm-10 how do you like it compared to say the caddy

I love the PFM10, works awesome on technical layouts.

In my opinion the new corvette and the Pzero I run identicle lap times with med traction conditions as traction came up the corvette was better (less down force)
So I'm guessing on low bite the Pzero would be the go too body

Is there a body height rule like in TC?

Not that I can think of. I think the closest that it gets is that you can cut above the molded-in trim line on any body. I don't know if it's in the rules or not, but Rob or Kevin have also said that the body should have a 5mm minimum height, just like the chassis.

If you can find Mr. Color thinner, it works great and wont mess up the plastic.

Wow I friggin love this.