Losi XXL2-E
#1471
Tech Addict
iTrader: (17)
Shock Cartridge Tool
Planning on doing a rebuild on my shocks. The plastic tools for the shock cap and cartridge are a one time use only tool IMO. I looke pretty much everywhere it couldn't find say an aluminum one that would fit the giant 22mm cartridge. Anybody use something different than the plastic tools?
#1472
Tech Addict
I used mine quite often, but you can also use a box end wrench, a open end wrench, or an adjustable wrench.
Or a deep wall ( well? ) socket if you do not need the shock fully extended.
Or a deep wall ( well? ) socket if you do not need the shock fully extended.
#1473
Tech Initiate
Does anybody know how to convert an OS .28 xz to a spin start / rotostart? I mean what exact parts are actually compatible?
#1474
Tech Master
iTrader: (140)
I seem to recall seeing somebody do this conversion once so it should at least be possible, but I can't recall what parts they needed.
#1476
Tech Champion
It was done by somebody in Australia, way back when on lstforums.. I don't remember the details of how it was done, but I think it wasn't simple..
#1477
I do
You need a crank and its not worth it.
going from a roto start to bump start was easier...just remove the pin on the end of the crankl.
Either way that was always a pain and risked the engine if you don't know what you are doing.
Get a pull start engine and convert its easier and you don't have to mess with the crank.
You need a crank and its not worth it.
going from a roto start to bump start was easier...just remove the pin on the end of the crankl.
Either way that was always a pain and risked the engine if you don't know what you are doing.
Get a pull start engine and convert its easier and you don't have to mess with the crank.
#1480
Tech Rookie
Got your back guys
#1482
Tech Adept
will the stock receiver fit inside the rpm rx box?
https://www.amainhobbies.com/rpm-rec...pm80052/p39273
https://www.amainhobbies.com/rpm-rec...pm80052/p39273
#1483
Tech Addict
iTrader: (17)
will the stock receiver fit inside the rpm rx box?
https://www.amainhobbies.com/rpm-rec...pm80052/p39273
https://www.amainhobbies.com/rpm-rec...pm80052/p39273
rpm rx box Interior Dimensions (LxWxH): 2.135x1.075x1.4"
Spektrum RC SRS4210 Dimensions
Length: 1.43 in (36.3mm)
Width: 0.96 in (24.4mm)
Height: 0.51 in (13.0mm)
#1484
Tech Adept
#1485
Tech Initiate
Just ordered NEW xxl2-e
New truck will be here this week. Plan on running 4s only....at this time. I've ordered all new screws for the truck as I have read this is a good thing to do. Also ordered rc raven springs., losi 8ight 17mm 1/2+ hex adapters, proline trencher x's, hd diff housing with shims, rear bumper and wing, I'm I missing anything that I should mod on this beast....should I run a bec on this system? Thanks for any help...I had a losi xxl 454, back in the day, sold all my rc's.....now back in it....just built yeti XL, now this because I loved my xxl, but going all electric this time around,