Tekno RC EB48.3 Thread
#2252
Suspended
iTrader: (-1)
Joined: May 2016
Posts: 272
From: Daytona, FL
I don't feel like mine were really that tight... but I would stop after a run and the strap would be cut/broken where it meets the chassis. I don't pull on them hard, just enough so the battery isn't moving around. :/
3 in 1 week is too many though...
3 in 1 week is too many though...
#2254
I would check and make sure there are no sharp edges on the battery tray where the straps go thru. Use some light sandpaper or a hobby knife and round the edges of the plastic a bit. also make sure you are using both front slots or both rear, if you put the strap thru both outside slots then your battery will be sliding back and forth and may put extra stress on the straps.
#2257
Suspended
iTrader: (-1)
Joined: May 2016
Posts: 272
From: Daytona, FL
hmm... same, my sct hasn't had any issues.. but my eb broke 3 this week. I took it off after the first time and tried to round down the edges (they looked fine), i bought some mugen straps from the lhs to get me through the day, but they are only the short straps. ill take off the side again and rub it down again and see whats going on.... cause it does seem like its getting cut by the side, but its rounded.. so i don't understand how?!? haha
#2258





22Likes