Tamiya TB Evo 6
#1111
What spur brands and sizes fit?
#1113
#1115
Thanks!
#1116
Exo 6 Photos
I found a few pics from last month's ROAR Nationals and have attached them for your viewing leisure...enjoy!
#1117
Tech Elite
iTrader: (66)
Hat has everyone been doing about the chubs made of glass. I broke 4 left fronts l. 2 in 17.5, and 2 in GT. About to start my main in GT and going to run with a broken one because I used all my spares.
Other than that this car is on point. The setup I put on it when I built them was a great starting point. Only minor RC and a spring tweaking to do. This car responds really well to set up changes.
Other than that this car is on point. The setup I put on it when I built them was a great starting point. Only minor RC and a spring tweaking to do. This car responds really well to set up changes.
#1118
Tech Master
Square do some excellent alloy c-hubs but they are 5 degrees. Else just use the 417 parts as they are stronger but you will need different shims etc
#1119
You can also use non carbon reinforced plastic chubs as well.
#1121
Tech Fanatic
iTrader: (34)
#1123
What spring set to purchase I have the black edition? I run on medium to high grip carpet.
#1125
Hat has everyone been doing about the chubs made of glass. I broke 4 left fronts l. 2 in 17.5, and 2 in GT. About to start my main in GT and going to run with a broken one because I used all my spares.
Other than that this car is on point. The setup I put on it when I built them was a great starting point. Only minor RC and a spring tweaking to do. This car responds really well to set up changes.
Other than that this car is on point. The setup I put on it when I built them was a great starting point. Only minor RC and a spring tweaking to do. This car responds really well to set up changes.
You might can find the 5 degree ones easier, but not sure if you would like the handling? I dunno, never had a set.