HELP choosing a servo for 1/10 buggy ?
09-06-2013 | 08:22 PM
#16
After you strip a couple cheap servos or find your RC pushing in corners due to lack of servo torque then you'll figure out there is no such thing as overdoing it. I'd rather have too much than not enough.
I also prefer to run the same model servo in all my stuff in case I need to swap them around to test or "borrow" one from another one of my cars at the track.
I also prefer to run the same model servo in all my stuff in case I need to swap them around to test or "borrow" one from another one of my cars at the track.
Thanks ill be ordering one soon
One more question I did the rear motor mount on my 22 2.0 but I got confuse on the spur gear I ended up putting the 78 spur the one included on the kit now the question is if the spur gear goes with my tekin rs pro 10.5t ????? And I don't know which pinion to put on it since I don't know much about how that works
12-16-2013 | 01:25 AM
#18
So for my losi 22 2.0 I ended up getting the hitec 7940 which is a digital high voltage 
SO FOR MY UPCOMING BUGGY ILL BE GETTING THE NEW LOSI 22-4 I WAS WONDERING IF THE HITEC 7940 WOULD BE OK TOO ????
SO FOR MY UPCOMING BUGGY ILL BE GETTING THE NEW LOSI 22-4 I WAS WONDERING IF THE HITEC 7940 WOULD BE OK TOO ????
12-16-2013 | 06:00 AM
#19
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
