Thank you for your kind words .All we can do is our best

So after installed a new speedo same problem, after testing conclusion on that precise moment the turbo was kicking in and messing up with the brake now all OK. Thanks.

Friends, help. I researched a bit about Fleta 4, but very little is said about it yet. It is possible to place the software on esc lcd card and the HW?

I believe the Much More Fleta4 is a re branded Speed Passion Reventon Pro. More than likely the software will not work as Hobbywing does not manufacture OEM esc's for Speed passion any more.

Cheers
Rob.

Correct.

Hi guys

Just a heads up we have a delay on roar approved motors and i dnt have any confirmed release date.You still can buy the first version of the motors but they are not approved roar legal at this stage not saying the first wont be but at this stage they are mot approved.

Seems like there's a delay at ROAR for other brands of motors along with Hobbywing. Just out of curiosity, does Hobbywing submit their motors for approval with other governing bodies such as the BRCA ?(I think that's the correct body) because in some events here the motors can be approved on other lists to be able to used in said events.

Cheers
Rob.

The BRCA lists for all motors are here if you want to check. HTH

http://www.brca.org/index.php?q=cont...-updates/14218

I have the new 3.1 1S and it will not connect to the programming box, any quick suggestions on what i could be doing wrong?

You connecting thru the port on the Esc and not using the cable to the receiver? It doesn't connect like the older models.

Whoa - didn't know that, I will try, thanks!

Hello there. I'm currently using a v3.1 in blinkly with a 21.5 motor. I have the punch rate at 30, but my question is my bottom end feels flat compared to my v2.1 what other setting can I alter to get more low end.

Any tips on a base setup for a v3.1 1cell?
What firmware is best for 1/12 mod?
I am using 4,5-5,5T Muchmore motors, what rollout and base settings should I use?

Is it possible to disable the "power off after holding brake for 5 seconds" function on the esc? This functionality means this esc is unusable on tracks that have sloped starting positions where you need to hold brake to stop rolling... It's not good having your car turn off on the starting grid

Don't think its possible. For situations like those, I turn up the initial brake to 25 percent or so. The initial does not affect any other parameters like drag brake etc. So cars pretty solid without throttle kinda like a handbrake .