Your paying for oversees shipping with the other brands as well, but it's built into the cost. If you don't need them right away you can do the second option which is like $20 and I usually get those in about a week and a half.

I started with the nano-techs since I was able to get 2 packs with the 3day shipping cheaper than one set from a local retailer.

They have worked well for me so far, but only have a bout a dozen runs on them each. They last a whole race for me no problem, don't notice them falling off till around the 10 min mark.

good info!

Got pics?

looks like part numbers for the AE saddle pack parts are:

91185 Battery cradle left and right side battery, strap bushing, strap lock
91186 Saddle Pack foam
25202 M3 x10mm fhcs x 4 screws
89208 M3 x 14mm fhcs
4689 M3 x 16mm set screw
91187 Saddle pack battery strap

Those of you ordering stuff from HK need to remember about Chinese new year. It'll take a while.

anyone see the new factory team kit?

Started on page 1079.

^ Kinda like that at&t 4g commercial...so 25 seconds ago.

Which "work great". The gens ace or turnigy?

349.99 on A Main and after discount 325.00.
http://www.amainhobbies.com/product_...Race-Truck-Kit

"great" is too subjective. What we really need is discharge charts from a 3rd party. Not sure if any are out there our not.

If the best gen's ace has is 25c then I would pass on those. I have a 5000mah 40c stick pack that causes cogging about half way though the pack with my setup, where my protek's and turnigy's have no issue.

Exotek came out with there new inline saddle pack brackets....

http://www.exotekracing.com/sc10-4x4...or-exotek-lcg/

ok this should be good.

http://www.teamassociated.com/news/l...ctory_Team_Kit!

AE makes pin retainers for them. But yeah, stock they float and held in at bearing.

Ok. Anyone got a part number for those retainers? Getting an error all of the sudden when i try to pull up there site.

The car has them stock, they are just not aluminum.