^thanks. i ended up just putting the stock rtr motor out of my sc10 in, a reedy 3300kv. i may upgrade to a 17.5 later on.
Originally Posted by
aeRayls
Rear
For JC wheels you'll need an sc10 rear hex for the rear!!!
Front
For JC wheels in front with JC axles you'll need sc10 rear hex!!!
For JC wheels in front with ae axles you'll need B4 rear hex!!!
man, i just saw this post AFTER i ordered my JC Axles and SC10 alum hexes (x4). looks like I lucked out when ordering.
here is what i ordered from aMain:
1 x JConcepts T4 12mm Hex Conversion Front Axle Set
(JCI2170)
2 x Team Associated 12mm Aluminum Rear Clamping Wheel Hex Set (Blue) (2)
(ASC9892)
today was my first day on the clay with my t4.1 and i used the AE SC10 plastic hexes on JC wheels, and wow were they snug fitting inside the wheels. it almost felt like they were too big, i had to push them into place with my hex driver. this was enough for me to say no thanks to the plastic and to order up the aluminum hexes, as well as the JC axles.