Originally Posted by jsamarin

Make sure your inner center belt tunnel screws arent too tight. if they are, it will not "telescope" under hard impacts, causing it to bend outwards. Ive done it before, and even with the chassis brace, the truck still has enough flex for this to happen.

Typically i bottom my screws out, then unthread them one complete turn.

Hope that helps

Originally Posted by Mizchief

Check to make sure your motor plate is in the groove. That was my issue when I had that problem

Originally Posted by toyoter91

I had this issue on my truck and I think the new owner of it said it had something to do with the motor plate not being straight as he recently fixed the issue.

Originally Posted by PastaBoyNY

Jeff, check all of the fasteners that hold the three pieces of the chassis together. Also, check the ends of your brace to see if it is broken. Hope that helps...


Sal