R/C Tech Forums - Search Results

Go Back  R/C Tech Forums > Search Forums
Reload this Page >

Search Results

Community
Wiki Posts
Search
 
Search: Posts Made By: mtpocketsracing
Showing results 1 to 25 of 500
Search took 0.09 seconds.
03-01-2015, 06:26 PM
Replies: 14
Views: 8,869
Posted By mtpocketsracing

look at it like this, how expensive are lipo...

look at it like this, how expensive are lipo batteries. only to have a cheap(less expensive) charger slowly ruin them. I believe that's what was happening to mine. 4s batteries are not cheap. ...
03-01-2015, 08:06 AM
Replies: 11
Views: 1,202
Posted By mtpocketsracing

I'm not a pro paiter so my thoughts on this could...

I'm not a pro paiter so my thoughts on this could be way off base. but I think if you sprayed it black and tried to remove it in spots all you're going to end up with is smears and not clean clear...
02-28-2015, 07:57 PM
Replies: 24
Views: 1,721
Posted By mtpocketsracing

look in the for sale section. I seen some...

look in the for sale section. I seen some airtronics M11X's for sale not long ago for under $200. one of them was so new looking it probably was never used. they were airtronics flagship radio...
02-28-2015, 07:21 PM
Replies: 12
Views: 920
Posted By mtpocketsracing

the hobbywing sct pro I think is roughly the same...

the hobbywing sct pro I think is roughly the same size maybe slightly wider as the tekin RX8 and it's only $90. a lot of the locals around here have moved to hobbywing. they last just as long and...
02-28-2015, 07:09 PM
Replies: 14
Views: 8,869
Posted By mtpocketsracing

check out the icharger 308 duo. I just got...

check out the icharger 308 duo. I just got mine this afternoon. it was able to balance a 4s of mine that would never balance on my other charger. coincidentally a hitec X4. it just doesn't have...
02-28-2015, 06:48 PM
Replies: 5
Views: 549
Posted By mtpocketsracing

weekend bump

weekend bump
02-28-2015, 03:46 PM
Replies: 3
Views: 563
Posted By mtpocketsracing

their toe in guage works just fine also. but...

their toe in guage works just fine also. but skip their ride height gauge. the losi one is a little bit nicer.
02-27-2015, 02:23 AM
Replies: 5
Views: 549
Posted By mtpocketsracing

Ttt

Ttt
02-26-2015, 12:23 PM
Replies: 10
Views: 1,742
Posted By mtpocketsracing

be careful with rustoleum. it wrinkled on me...

be careful with rustoleum. it wrinkled on me before. never had any kind of paint do that to me before and I've painted several motorcycles and a few cars before. it must of reacted with the parma...
02-26-2015, 02:10 AM
Replies: 5
Views: 549
Posted By mtpocketsracing

Reasonable offers. Need it sold

Reasonable offers. Need it sold
02-25-2015, 02:38 PM
Replies: 5
Views: 549
Posted By mtpocketsracing

bump

bump
02-24-2015, 02:51 PM
Replies: 5
Views: 549
Posted By mtpocketsracing

Hitec X4 multi charger (DC-IN Only)

this charger is a DC only charger. will charge 4 batteries at a time.
I upgraded to a more powerful charger so need to sell this. everything works and in 9/10 condition.

It comes with,
1. 3...
02-24-2015, 09:13 AM
Replies: 2
Views: 443
Posted By mtpocketsracing

I would contact hitec because they did a recall...

I would contact hitec because they did a recall on a x2 400 charger for a incorrect setting of the menu. They might have a new firmware that will correct the issue
02-24-2015, 03:01 AM
Replies: 3
Views: 528
Posted By mtpocketsracing

Are you sure it was the battery and not a over...

Are you sure it was the battery and not a over heat condition of the esc etc?
02-23-2015, 04:51 PM
Replies: 5
Views: 1,481
Posted By mtpocketsracing

if you have a harbor freight close by, $29 alum...

if you have a harbor freight close by, $29 alum case full of foam http://www.harborfreight.com/18-in-x-6-in-x-13-in-aluminum-case-69318-8538.html

it's actually decent quality. hinges are good,...
02-23-2015, 04:16 PM
Replies: 7
Views: 825
Posted By mtpocketsracing

the stuff in my link says it will last 2 full...

the stuff in my link says it will last 2 full years on each application
02-23-2015, 09:01 AM
Replies: 15
Views: 1,005
Posted By mtpocketsracing

Why dont you guys just buy a airtronics or...

Why dont you guys just buy a airtronics or futaba. They both accept lipo/LiFe batteries with no mods. And you dont have to worry about all that low battery power glitches too.
02-22-2015, 05:14 PM
Replies: 15
Views: 1,005
Posted By mtpocketsracing

hey yeah, if they are lasting that long in the...

hey yeah, if they are lasting that long in the radio they're worth it for ya.

I seen the review for the eneloop batteries from panasonic and they can be recharged 2 thousand times.. holy crap! ...
02-22-2015, 06:49 AM
Replies: 15
Views: 1,005
Posted By mtpocketsracing

I've always found it interesting that no name...

I've always found it interesting that no name brand companies like panasonic, raovac, duracell etc don't make them. only some cheap no name brand stuff from china. this is probably why.

here's a...
02-22-2015, 06:27 AM
Replies: 6
Views: 623
Posted By mtpocketsracing

if it's a nitro the engine is running backward. ...

if it's a nitro the engine is running backward. they can accidentally start and run backward.
02-22-2015, 06:13 AM
Replies: 15
Views: 1,005
Posted By mtpocketsracing

starting to see chargers being able to charge...

starting to see chargers being able to charge NiZn batteries now. the icharger 308, 406 4010 does. most sites don't list as being able to but the owners manual does.
02-22-2015, 06:08 AM
Replies: 7
Views: 825
Posted By mtpocketsracing

combine that with this,...

combine that with this, http://www.killerrc.com/product/korrosion-killer-2oz/ and you shouldn't have any issues ever again
02-21-2015, 09:34 AM
Replies: 10,039
Views: 1,674,372
Posted By mtpocketsracing

I know this is a very old and now pretty much...

I know this is a very old and now pretty much useless thread. I wish I had this car years ago.

I fixed the steering rack in my opinion much better than how team durango did and how they did in...
02-21-2015, 09:17 AM
Replies: 125
Views: 37,058
Posted By mtpocketsracing

I never seen this thing before. but i swear this...

I never seen this thing before. but i swear this idea came to me about a year ago to make something like this. if only I had my own cnc router or machine. they'd never let me make stuff at work....
02-20-2015, 01:11 PM
Replies: 12
Views: 1,476
Posted By mtpocketsracing

and it's been about -10F. not wind chill, but...

and it's been about -10F. not wind chill, but actually -10. the stuff they treat the roads with doesnt work at these temps.
Showing results 1 to 25 of 500
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.