R/C Tech Forums - Search Results
R/C Tech Forums

Go Back  R/C Tech Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Wiki Posts
Calendar
Today's Posts
Search
Vendor Directory
 
Page 1 of 20
1
2
3
11
Last »
Search: Posts Made By: Mauve
Showing results 1 to 25 of 499
Search took 0.05 seconds.
Forum: Electric Off-Road
09-06-2015, 05:21 PM
Replies: 5
Views: 503
Posted By Mauve

TKR4140 will work fine, that mount is for 36.2 to...

TKR4140 will work fine, that mount is for 36.2 to 40mm motors, the motor attaches to the mount via screws that bolt into the front end bell
Forum: Nitro Off-Road
08-18-2015, 08:09 PM
Replies: 32
Views: 4,367
Posted By Mauve

I make sure I'm well prepared prior to the race,...

I make sure I'm well prepared prior to the race, try and sit for 5 minutes, close my eyes and not think, when I get on the stand I make sure I have wrap around glasses on to prevent wind and dust...
Forum: Nitro Off-Road
08-13-2015, 07:04 PM
Replies: 840
Views: 203,661
Posted By Mauve

There you go, an editable setup sheet for the...

There you go, an editable setup sheet for the Soar 998, its also 2.09% the size of the one you can download of the soar website so its not going to brutalise your interwebz.
Forum: Electric Off-Road
07-27-2015, 12:03 AM
Replies: 2,107
Views: 685,673
Posted By Mauve

What I have done with Mugen diff gears and never...

What I have done with Mugen diff gears and never had a problem is as follows.
On initial build, I will set the gear mesh with shims if required. I will then run a solid one day race meet, then...
Forum: Radio and Electronics
07-16-2015, 05:35 PM
Replies: 13,880
Views: 1,880,837
Posted By Mauve

The hobbywing program box can store 3 profiles,...

The hobbywing program box can store 3 profiles, each profile can be individually adjusted through hooking up to a computer. From factory, the first profile they have called a Practice mode which has...
Forum: Electric Off-Road
07-02-2015, 05:39 PM
Replies: 2,107
Views: 685,673
Posted By Mauve

Aftermarket screws aren't necessary with the...

Aftermarket screws aren't necessary with the Mugen from my prospective. The mugen stuff is up there with the best of them. I've used RCsrewz and Tony's before and found them to be no better than...
Forum: Painting, Designs, Graphics and Photography
06-29-2015, 10:56 PM
Replies: 7
Views: 904
Posted By Mauve

http://www.airbrushmegastore.com/index.php?option=...

http://www.airbrushmegastore.com/index.php?option=com_virtuemart&page=shop.browse&category_id=1196&Itemid=1

AutoAir Colors 4425 Hi-Lite Purple over black.
Forum: Painting, Designs, Graphics and Photography
06-29-2015, 10:56 PM
Replies: 7
Views: 904
Posted By Mauve

http://www.airbrushmegastore.com/index.php?option=...

http://www.airbrushmegastore.com/index.php?option=com_virtuemart&page=shop.browse&category_id=1196&Itemid=1

AutoAir Colors 4425 Hi-Lite Purple over black.
Forum: Nitro Off-Road
06-28-2015, 07:26 PM
Replies: 3,927
Views: 1,121,765
Posted By Mauve

Its a little hard to suggest things with just...

Its a little hard to suggest things with just diff oils and shock oils and very little description as to where your car lacks, with Astroturf, I would have thought that 7/5/3 is very light, with that...
Forum: Radio and Electronics
06-15-2015, 12:10 AM
Replies: 13,880
Views: 1,880,837
Posted By Mauve

Carter is right on this one, an M11x radio has...

Carter is right on this one, an M11x radio has 4096 resolution (5200 Ohm Pot) between full brake and full throttle, so the signal it sends to the receiver is accurate to 0.048% for throttle when the...
Forum: Radio and Electronics
06-14-2015, 05:04 PM
Replies: 13,880
Views: 1,880,837
Posted By Mauve

Just pull the red wire from the esc lead to the...

Just pull the red wire from the esc lead to the rx, then make sure you have your receiver pack plugged in and turned on prior to turning the ESC on when you run the car
Forum: Nitro Off-Road
06-01-2015, 09:52 PM
Replies: 54
Views: 18,393
Posted By Mauve

oh, thread necromancy

oh, thread necromancy
Forum: Electric Off-Road
06-01-2015, 06:31 PM
Replies: 14
Views: 990
Posted By Mauve

Hi Italo2275 The Mugen is no harder to...

Hi Italo2275

The Mugen is no harder to drive, how fast a car is is far more dependent on the drivers skill set, car setup and little bit of luck. I will say however that the Mugen is more durable...
Forum: Electric Off-Road
05-26-2015, 11:45 PM
Replies: 2,107
Views: 685,673
Posted By Mauve

I would look at your current limiter settings, I...

I would look at your current limiter settings, I did this in loose conditions the other weekend and it made a huge difference. The little bit below is from Randy Pike's RC Blog (he's the team...
Forum: Electric Off-Road
05-07-2015, 08:46 PM
Replies: 143
Views: 80,401
Posted By Mauve

Just watched your latest Video on the MBX7R-Eco...

Just watched your latest Video on the MBX7R-Eco and think you pretty much hit the nail on the head from all counts. I've run Mugen for 5 years now and I was curious to see your insight after just a...
Forum: Electric Off-Road
04-26-2015, 05:09 AM
Replies: 2,107
Views: 685,673
Posted By Mauve

Dont worry about your mesh being a touch tight...

Dont worry about your mesh being a touch tight for starters with no shims, it will loosen up after 30 mins to and hours running, just check it after your first race meet. The car will loosen up and...
Forum: Nitro Off-Road
03-25-2015, 09:52 PM
Replies: 3,927
Views: 1,121,765
Posted By Mauve

I just use Mobil 1 Lithium Grease (mobilith),...

I just use Mobil 1 Lithium Grease (mobilith), also use it to pack the centre drive line CVD's. Seams to prolong their life pretty significantly. The copper coloured RB grease is really good as well.
Forum: Australian Racing
10-08-2014, 05:07 PM
Replies: 584
Views: 41,834
Posted By Mauve

I'll be entirely honest, 95% of the proposal is a...

I'll be entirely honest, 95% of the proposal is a great idea and the way forward. I do have concerns over the $500 for affiliation as a funding model. It goes some length to alienate the small...
Forum: Australian Racing
09-04-2014, 04:00 PM
Replies: 19,750
Views: 1,512,541
Posted By Mauve

Pretty sure Mick Bellman and Mark Kirk will be...

Pretty sure Mick Bellman and Mark Kirk will be racing as the Adelaide round in ep as well
Forum: Nitro Off-Road
07-28-2014, 07:27 PM
Replies: 40
Views: 4,289
Posted By Mauve

I generally keep a pair of mechanics gloves in my...

I generally keep a pair of mechanics gloves in my pit bag to prevent myself from burns and jags on sharp edges, I have a set of motorbike riders sunnies that have a seal to prevent wind which stops...
Forum: Nitro Off-Road
07-23-2014, 07:02 PM
Replies: 131
Views: 28,455
Posted By Mauve

Agama - Never owned Associated - My RC8T was...

Agama - Never owned
Associated - My RC8T was great, to many horror stories from good mates to even consider the buggy.
Durango - Never owned, rare in oz
Hot Bodies -Never owned but I barely see...
Forum: Nitro Off-Road
07-21-2014, 07:43 AM
Replies: 947
Views: 258,522
Posted By Mauve

Has anyone snapped a axle stub? I don't know what...

Has anyone snapped a axle stub? I don't know what happened but I packed up my car in one piece, pulled it out to race and one of the front wheels fell off. The hub is still in the wheel and the pin...
Forum: Nitro Off-Road
07-18-2014, 12:05 AM
Replies: 4,347
Views: 1,155,856
Posted By Mauve

I put a shim behind the pinion to move it forward...

I put a shim behind the pinion to move it forward a bees whisker and once all bolted together was spot on.
Forum: Nitro Off-Road
07-13-2014, 05:50 PM
Replies: 947
Views: 258,522
Posted By Mauve

I had my first run with my MBX7T yesterday and am...

I had my first run with my MBX7T yesterday and am extremely happy with the truck. I have replaced the upper pillow balls with steel ones during the build so had no problems with pillow ball breaks. ...
Forum: Australian Racing
07-13-2014, 04:56 PM
Replies: 227
Views: 28,654
Posted By Mauve

Big thanks to Mikey Williams, Adam Price, Mark...

Big thanks to Mikey Williams, Adam Price, Mark Kirk and Bruce Pallant for all the hard work to drain off the track. It came up a treat really and I think a ball was had by all racing!
I had an...
Showing results 1 to 25 of 499
 
Page 1 of 20
1
2
3
11
Last »


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.