R/C Tech Forums - Search Results
R/C Tech Forums

Go Back  R/C Tech Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Wiki Posts
Calendar
Today's Posts
Search
Vendor Directory
 
Page 1 of 7
1
2
3
Last »
Search: Posts Made By: Signal151
Showing results 1 to 25 of 164
Search took 0.01 seconds.
Forum: Nitro Off-Road
10-01-2012, 10:14 AM
Replies: 317
Views: 29,046
Posted By Signal151

^^^ I couldn't agree more with the one...

^^^
I couldn't agree more with the one exception being the availability of parts three months prior to the Worlds. I have no problem with the Worlds event being a showcase for new and/or...
Forum: Offroad Nitro Engine Forum
05-11-2012, 05:26 PM
Replies: 91
Views: 14,060
Posted By Signal151

It may just be the photo but does that con rod...

It may just be the photo but does that con rod not have a knife edge?
Forum: Offroad Nitro Engine Forum
04-16-2012, 07:59 AM
Replies: 682
Views: 106,599
Posted By Signal151

Air filter maintenance and tune will play major...

Air filter maintenance and tune will play major factors but pretty much any LM engine is going to last a long time. I have an ORION MTE going on gallon six and it still has excellent compression. In...
Forum: Offroad Nitro Engine Forum
04-10-2012, 06:19 PM
Replies: 26
Views: 9,535
Posted By Signal151

Excellent points. Thanks Joey!

Excellent points. Thanks Joey!
Forum: Offroad Nitro Engine Forum
04-09-2012, 11:52 PM
Replies: 26
Views: 9,535
Posted By Signal151

I've often wondered this myself. I've always run...

I've often wondered this myself. I've always run 20% and never felt short on power v.s. those who run 30% (which is pretty much everyone else).
Forum: Offroad Nitro Engine Forum
03-31-2012, 10:06 AM
Replies: 106
Views: 16,630
Posted By Signal151

I call shennenigans! In all my years of racing...

I call shennenigans! In all my years of racing (since 1988) I've never heard of such a thing. All properly designed drive trains are indeed engineered to be a bit tight upon initial build so that...
Forum: Nitro Off-Road
07-21-2011, 06:16 PM
Replies: 74
Views: 10,629
Posted By Signal151

As a one-weekend-a-month warrior, I...

As a one-weekend-a-month warrior, I wholeheartedly dispute that "fact". The Durango is quite easy to set up and to get handling properly. For me, it was easier to set up than my Losi.
Forum: Nitro Off-Road
07-21-2011, 06:11 PM
Replies: 74
Views: 10,629
Posted By Signal151

Well we'll have to agree to disagree on the...

Well we'll have to agree to disagree on the concept of the Durango vehicles being "over engineered". The 408's design is brilliant in my opinion but not perfect. If it weren't for the leaking fuel...
Forum: Nitro Off-Road
07-21-2011, 11:17 AM
Replies: 74
Views: 10,629
Posted By Signal151

I think TD is trying to do too much at once with...

I think TD is trying to do too much at once with too many products in the pipeline. I would have preferred that they work the kinks out of the DNX408 before moving on to a E-buggy or a Truggy. If...
Forum: Texas Racing
05-20-2011, 11:37 PM
Replies: 7
Views: 1,049
Posted By Signal151

I think I am going to try and make it out and run...

I think I am going to try and make it out and run some laps!
Forum: Nitro Off-Road
04-07-2011, 10:45 AM
Replies: 9
Views: 2,003
Posted By Signal151

I have this box and I believe it is the the Ofna...

I have this box and I believe it is the the Ofna Truggy box just relabeled with a different top plate and peg system.

It works great for my Durango DNX408. I have a 12v gel pack in it for power.
Forum: Nitro Off-Road
02-23-2011, 05:17 PM
Replies: 10,039
Views: 1,674,368
Posted By Signal151

Those are the measurements for the suspension...

Those are the measurements for the suspension spacers. When you look at the diagram be careful to note where the pointer line is going for each measurement. For instance, on the rear suspension there...
Forum: Nitro Off-Road
02-23-2011, 01:33 PM
Replies: 10,039
Views: 1,674,368
Posted By Signal151

I drove the stock setup and agree that the rear...

I drove the stock setup and agree that the rear was quite loose. Since then I have made a number of changes and have a setup posted on the Team Durango website. My goal is a fairly neutral car that...
Forum: Nitro Off-Road
02-17-2011, 10:01 PM
Replies: 138
Views: 22,378
Posted By Signal151

Looks very interesting! I'm not sure about the...

Looks very interesting! I'm not sure about the receiver batter being under the fuel tank, if that's really where the designers placed it. But then again, I wasn't keen on the Durango's placement of...
Forum: Nitro Off-Road
02-12-2011, 11:09 PM
Replies: 10,039
Views: 1,674,368
Posted By Signal151

You'll need to grind your chassis some to use...

You'll need to grind your chassis some to use that box, especially if you're using a 34mm aftermarket flywheel on your engine. Unfortunately, as far as I can tell, the Dynamite DM box is just a...
Forum: Nitro Off-Road
02-10-2011, 01:10 PM
Replies: 10,039
Views: 1,674,368
Posted By Signal151

Hrm... I'd like to see it in person. From that...

Hrm... I'd like to see it in person. From that picture it seems a little small and shallow.
Forum: Nitro Off-Road
02-10-2011, 12:58 PM
Replies: 39
Views: 17,879
Posted By Signal151

I've run Losi oils pretty much my entire racing...

I've run Losi oils pretty much my entire racing career that goes back to 1988. In all that time I cannot say I've ever witnessed a noticable inconsistency in any of their oil products.

That said,...
Forum: Offroad Nitro Engine Forum
02-08-2011, 08:20 PM
Replies: 127
Views: 41,570
Posted By Signal151

Uhm.. what the... what are you people doing?!?...

Uhm.. what the... what are you people doing?!? Showing me this??! Now I'm going to have to spend another $600!!! ZOMG!!!
Forum: Nitro Off-Road
02-08-2011, 07:57 PM
Replies: 10,039
Views: 1,674,368
Posted By Signal151

Put it over the threads that the bottom (red)...

Put it over the threads that the bottom (red) shock cap screws on to. Push it all the way over the threads so that it seats in the corner where the shock body widens. Then screw the red shock cap...
Forum: Nitro Off-Road
02-08-2011, 04:21 PM
Replies: 9
Views: 1,048
Posted By Signal151

ROFL!

ROFL!
Forum: Nitro Off-Road
02-08-2011, 04:02 PM
Replies: 12,022
Views: 1,753,020
Posted By Signal151

Too true unfortunately. But on the flip side this...

Too true unfortunately. But on the flip side this will pay off for you in the long run. Good business is about building and honoring relationships and always striving to leave people better off than...
Forum: Offroad Nitro Engine Forum
02-03-2011, 01:49 PM
Replies: 159
Views: 21,803
Posted By Signal151

I have no idea what the company's marketing hype...

I have no idea what the company's marketing hype is, but there's no way for any of us to know the answer to your question yet. Only getting our hands on the product and testing will tell. Looks very...
Forum: Offroad Nitro Engine Forum
02-02-2011, 10:27 PM
Replies: 159
Views: 21,803
Posted By Signal151

Thanks! That's reassuring. :smile:

Thanks! That's reassuring. :smile:
Forum: Offroad Nitro Engine Forum
02-02-2011, 10:22 PM
Replies: 159
Views: 21,803
Posted By Signal151

Good because I recently purchased a pair of the...

Good because I recently purchased a pair of the MTEs for the 2011 season and would hate to find out now that I shouldn't have. I supposed Mike jumping ship explaines why the engines are being dumped...
Forum: Offroad Nitro Engine Forum
02-02-2011, 10:06 PM
Replies: 159
Views: 21,803
Posted By Signal151

Wait, are we now to believe that Star/LM engines...

Wait, are we now to believe that Star/LM engines are somehow sub-par? Didn't one just win the worlds? :nod:

Ah well, this new crank has my interest piqued but I'm not going to be one of the first...
Showing results 1 to 25 of 164
 
Page 1 of 7
1
2
3
Last »


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.