R/C Tech Forums - Search Results

Go Back  R/C Tech Forums > Search Forums
Reload this Page >

Search Results

Community
Wiki Posts
Search
Search: Posts Made By: BBP
Showing results 1 to 8 of 8
Search took 0.01 seconds.
10-22-2011, 08:25 AM
Replies: 9,093
Views: 1,267,674
Posted By BBP

hi there, i just recently bought photon. My car...

hi there, i just recently bought photon. My car cannot go straight, i wonder what i should check out?
"trim" from the remote has already been tried to make the car go straight..but it didnt work out...
08-04-2011, 07:43 AM
Replies: 2,969
Views: 556,228
Posted By BBP

Ok thanks Bob, will give it a try

Ok thanks Bob, will give it a try
08-03-2011, 02:49 AM
Replies: 2,969
Views: 556,228
Posted By BBP

Guys, I am running orca 11,5T with LRP SXX ESC,...

Guys, I am running orca 11,5T with LRP SXX ESC, with 64p 103T spur gear and pinion gear is 34T. After several laps running, the motor is very hot. I think the spur and pinior gear are not matched....
07-29-2011, 12:02 AM
Replies: 0
Views: 374
Posted By BBP

Question on LRP SXX stock specs

Guys, my car is not working at all. Before it shut down, it sounds "beep" for a few seconds.
I need a help, what I should do?

Motor : Orca X1
ESC : LRP SXX stock specs

Thank you guys
07-26-2011, 06:44 PM
Replies: 4
Views: 780
Posted By BBP

Do you know where in Singapore I can buy this...

Do you know where in Singapore I can buy this exotex product?
07-26-2011, 08:02 AM
Replies: 4
Views: 780
Posted By BBP

TA 05 V II R conversion kit

Guys, I need an advise what conversion kit I should get for TA 05 V II R? And where can i get it in Singapore?

Thanks before
07-17-2011, 10:27 PM
Replies: 1
Views: 913
Posted By BBP

Combination for Spur Gear and Pinion Gear

Masters,
i need your advice for the combination for Spur and Pinion Gear. I have Orca 11,5 T and ESC SXX stock specs. Currently, I use 64 pitch 103T for the spur gear, what is the pinion gear I...
07-09-2011, 11:04 PM
Replies: 3
Views: 663
Posted By BBP

Have a problem with cornering, pls HELP

Hi guys, I'm running a TA 05 VII R with tamiya brushless 10,5T. Have problem with cornering, everytime i make a turn, it is so wide open. Can you guys help me?
Showing results 1 to 8 of 8


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.