R/C Tech Forums - Search Results
R/C Tech Forums

Go Back  R/C Tech Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Wiki Posts
Calendar
Today's Posts
Search
Vendor Directory
 
Page 1 of 8
1
2
3
Last »
Search: Posts Made By: MTseo
Showing results 1 to 25 of 179
Search took 0.01 seconds.
Forum: Micro and Mini Scales
06-08-2020, 08:34 PM
Replies: 7,833
Views: 1,807,307
Posted By MTseo

I have an evo that I have switched from brushless...

I have an evo that I have switched from brushless to brushed. The blue light flashes now that it is in brushed mode.
Forum: Micro and Mini Scales
05-27-2020, 07:41 PM
Replies: 5
Views: 5,328
Posted By MTseo

https://cimg6.ibsrv.net/gimg/www.rctech.net-vbulle...

https://cimg6.ibsrv.net/gimg/www.rctech.net-vbulletin/1008x756/20200527_195436_1008x756_39da98568fb842839b22f0140a9dd5a59e200841.jpg
I took the diffs apart again and double checked everything was...
Forum: Micro and Mini Scales
05-18-2020, 10:27 PM
Replies: 5
Views: 5,328
Posted By MTseo

That was a good deal. I am not sure what made me...

That was a good deal. I am not sure what made me go with this over the GLA, but I went back and forth on which ones to build. I knew the GL would be a nice easy structured build, but it just seemed...
Forum: Micro and Mini Scales
05-18-2020, 10:10 PM
Replies: 5
Views: 5,328
Posted By MTseo

https://cimg4.ibsrv.net/gimg/www.rctech.net-vbulle...

https://cimg4.ibsrv.net/gimg/www.rctech.net-vbulletin/1008x756/20200518_182354_1008x756_8156020d7a22e51a3f45f8f1f8deab8ac5ff8315.jpg
I got to this point and then took all of the ball joint back off...
Forum: Micro and Mini Scales
05-17-2020, 09:19 PM
Replies: 5
Views: 5,328
Posted By MTseo

I just bought a couple of bz3 kits to build and...

I just bought a couple of bz3 kits to build and have noticed a lack of info on these cars also. The lack of helpful info made me hesitant to buy them, there are a lot of different parts for...
Forum: Micro and Mini Scales
04-16-2020, 10:28 PM
Replies: 501
Views: 116,427
Posted By MTseo

https://www.microrcsyndicate.com/ Has the...

https://www.microrcsyndicate.com/

Has the sanwa micro rx here in the states if that is where you are located. He ships pretty quick.
Forum: Micro and Mini Scales
04-16-2020, 06:43 PM
Replies: 501
Views: 116,427
Posted By MTseo

https://www.rcmart.com/sanwa-mt-s-4-channel-radio-...

https://www.rcmart.com/sanwa-mt-s-4-channel-radio-kit-fh4-fh4-ssr-for-rc-car-mt-s-00066929

There is the best deal. Takes a little while for shipping but saves a lot of money.
Forum: Micro and Mini Scales
04-13-2020, 07:31 PM
Replies: 7,833
Views: 1,807,307
Posted By MTseo

Banzai has some. May take a week to get from...

Banzai has some. May take a week to get from Japan though.

https://banzaihobby.com/radio-control/kyosho-miniz/mr-015-parts/diff-gear-assembly-mr-02-015-mini-z
Forum: Micro and Mini Scales
03-31-2020, 07:11 PM
Replies: 7,833
Views: 1,807,307
Posted By MTseo

I would keep your rtr. Box stock cars are a lot...

I would keep your rtr. Box stock cars are a lot of fun and most clubs have a box stock class or close to box stock class to race. It is some of the closest racing that I have been a part of and a...
Forum: Micro and Mini Scales
03-27-2020, 03:42 AM
Replies: 704
Views: 201,125
Posted By MTseo

I had bought several sets of pn ks super soft...

I had bought several sets of pn ks super soft front tires to use on the rear of my GLF1 last fall. I was using the 14mm pn rims and put 2 of the front tires on to make a super soft rear. As marka...
Forum: Micro and Mini Scales
03-27-2020, 03:21 AM
Replies: 7,833
Views: 1,807,307
Posted By MTseo

For the VE losing traction. Loosen the wheel...

For the VE losing traction. Loosen the wheel nuts a little to see if that helps. If that is not it check to make sure the tplate is not cracked and check to make sure the screws that hold it down...
Forum: Micro and Mini Scales
03-25-2020, 04:21 AM
Replies: 704
Views: 201,125
Posted By MTseo

The new Marka V1 5deg rear tire seems like a good...

The new Marka V1 5deg rear tire seems like a good replacement tire for the ks super soft tire. I have put a few thousand laps on my evo 5500kv car with the marka rears and I have ordered more to add...
Forum: Micro and Mini Scales
03-16-2020, 04:52 PM
Replies: 501
Views: 116,427
Posted By MTseo

Several people have successfully reinforced the...

Several people have successfully reinforced the end that breaks with different materials. I used a sliver of plastic and wrapped around the circumference of the end that breaks and super glued it . ...
Forum: Micro and Mini Scales
03-06-2020, 11:47 PM
Replies: 704
Views: 201,125
Posted By MTseo

Are you saying swap wire no. 2 and wire no. 3 if...

Are you saying swap wire no. 2 and wire no. 3 if you use a sensored motor other than a GL sensored motor with a GL sensored esc?
Forum: Micro and Mini Scales
03-05-2020, 09:45 PM
Replies: 7,833
Views: 1,807,307
Posted By MTseo

For the evo all of the brushless motors that I...

For the evo all of the brushless motors that I have wired have all ended up the same.
Left wire from board goes to the first motor terminal.
Middle wire from board goes to the 3rd motor...
Forum: Micro and Mini Scales
03-04-2020, 08:06 PM
Replies: 704
Views: 201,125
Posted By MTseo

I ran the GL sensored esc with a GL sensored...

I ran the GL sensored esc with a GL sensored 5500kv motor. The esc never did seem to run very well, it always took a long time to turn on and the response was a little on the slow side. The esc did...
Forum: Micro and Mini Scales
02-28-2020, 08:45 AM
Replies: 7,833
Views: 1,807,307
Posted By MTseo

The motor should sit parallel to the...

The motor should sit parallel to the differential. For the mounting plate make sure that the long screw is in the position shown in the directions. That screw passes through the mounting plate and...
Forum: Micro and Mini Scales
02-22-2020, 10:53 AM
Replies: 7,833
Views: 1,807,307
Posted By MTseo

We may be racing at the same track, EN hobbies. ...

We may be racing at the same track, EN hobbies. My box stock is handling pretty good there the last time I was there. I am running pn ks medium rears and pn ks firm fronts. I did true the front...
Forum: Micro and Mini Scales
02-21-2020, 02:02 PM
Replies: 7,833
Views: 1,807,307
Posted By MTseo

You should make the trip to Maddison on a Friday...

You should make the trip to Maddison on a Friday night. Tracks Hobbies probably has the largest permanent rcp track in the country. My family and I made the drive last year from Ohio and had a...
Forum: Micro and Mini Scales
02-16-2020, 09:20 PM
Replies: 7,833
Views: 1,807,307
Posted By MTseo

I have heard of this problem many times with the...

I have heard of this problem many times with the mr03 rwd board. The board with the white antena. I have not heard of it happening to the sports board. On the rwd board I have not been able to find...
Forum: Micro and Mini Scales
02-15-2020, 07:27 PM
Replies: 7,833
Views: 1,807,307
Posted By MTseo

You guys should join HFAY and start submitting...

You guys should join HFAY and start submitting your races. HFAY has really grown over the last year. There are many clubs from around the globe competing now. There is a How Fast Are You FB group...
Forum: Micro and Mini Scales
02-12-2020, 09:19 AM
Replies: 501
Views: 116,427
Posted By MTseo

microrcsyndicate.com is taking care of the bad...

microrcsyndicate.com is taking care of the bad esc for me. He is an easy guy to work with.
Forum: Micro and Mini Scales
02-09-2020, 11:30 AM
Replies: 501
Views: 116,427
Posted By MTseo

They messaged me this morning through FB and told...

They messaged me this morning through FB and told me to get in touch with my local GL dealer.
Forum: Micro and Mini Scales
02-09-2020, 04:06 AM
Replies: 501
Views: 116,427
Posted By MTseo

Thanks EMU I didn't realize they were still...

Thanks EMU I didn't realize they were still celebrating the new year. That is probably the reason they are not responding.
Forum: Micro and Mini Scales
02-08-2020, 08:10 PM
Replies: 501
Views: 116,427
Posted By MTseo

Has anybody had luck with getting a replacement...

Has anybody had luck with getting a replacement part through GL? I bought one of their sensored esc's for my F1 but a couple weeks ago it stopped working. It will not power on at all. I have sent...
Showing results 1 to 25 of 179
 
Page 1 of 8
1
2
3
Last »


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.