R/C Tech Forums - Search Results
R/C Tech Forums

Go Back  R/C Tech Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Wiki Posts
Calendar
Today's Posts
Search
Vendor Directory
 
Page 1 of 20
1
2
3
11
Last »
Search: Posts Made By: Danny B
Showing results 1 to 25 of 500
Search took 0.03 seconds.
Forum: Nitro Off-Road
10-18-2016, 06:03 AM
Replies: 9
Views: 2,659
Posted By Danny B

http://www.horizonhobby.com/ready-start-dm-starter...

http://www.horizonhobby.com/ready-start-dm-starter-box-universal-dyn5650

Found that to be a very nice box for the money. Same design as the ofna box minus the stupid pulley. so I would just take...
Forum: Nitro Off-Road
05-16-2016, 10:22 AM
Replies: 4,255
Views: 1,300,276
Posted By Danny B

Go to AE website look up setups and use the...

Go to AE website look up setups and use the "team" DNC setup. It describes the couple mods we're doing to the arms. You can also find Cav's under the hood photos from DNC on neobuggy.net for...
Forum: Nitro Off-Road
04-21-2016, 07:05 AM
Replies: 4,255
Views: 1,300,276
Posted By Danny B

The mugen air filter is quite a bit different...

The mugen air filter is quite a bit different than the AE. The car is equip to mount the stock air filter, the Losi filter body also works well. Losi(equivalent)filters for replacements.

You...
Forum: Nitro Off-Road
04-13-2016, 12:45 PM
Replies: 4,255
Views: 1,300,276
Posted By Danny B

Click on Dyno Dan's Profile and you can easily...

Click on Dyno Dan's Profile and you can easily find all is posts about the car!
Forum: Nitro Off-Road
04-04-2016, 10:30 AM
Replies: 4,255
Views: 1,300,276
Posted By Danny B

34mm

34mm
Forum: Nitro Off-Road
04-04-2016, 07:01 AM
Replies: 4,255
Views: 1,300,276
Posted By Danny B

Go back 3 or 4 pages, there was some discussion...

Go back 3 or 4 pages, there was some discussion about 4 shoe clutches. IMO, the Novarossi clutch is really good.
...
Forum: Nitro Off-Road
03-30-2016, 06:18 AM
Replies: 4,255
Views: 1,300,276
Posted By Danny B

It kinda depends on what engine you have. My...

It kinda depends on what engine you have. My buddy runs XZ speed and Losi Clutch fits fine. The Crankcase on the B2101 is different and the losi clutch is too far forward.

I've been running the...
Forum: Nitro Off-Road
03-22-2016, 01:33 PM
Replies: 800
Views: 192,362
Posted By Danny B

There are quite a few factors that can change the...

There are quite a few factors that can change the fuel mileage during a run. So saying its the pit guys fault is not true at all. Driver pushing harder, vehicle handling as tires wear, track...
Forum: Nitro Off-Road
03-07-2016, 01:37 PM
Replies: 4,255
Views: 1,300,276
Posted By Danny B

The diff cases are not the same. But I have no...

The diff cases are not the same. But I have no idea if/how the B3 diffs would fit. Someone that has both will have to help you on that.
Forum: Nitro Off-Road
03-03-2016, 06:41 AM
Replies: 4,255
Views: 1,300,276
Posted By Danny B

Avid RC sells 8 x 12 bearings

Avid RC sells 8 x 12 bearings
Forum: Nitro Off-Road
02-25-2016, 08:03 AM
Replies: 4,255
Views: 1,300,276
Posted By Danny B

I run the gaskets, I've ran it both ways, didn't...

I run the gaskets, I've ran it both ways, didn't really see much difference. I do run the standard gasket in the center of the E-Buggy not the thicker one that is supplied. I've been very happy with...
Forum: Nitro Off-Road
02-24-2016, 11:52 AM
Replies: 4,255
Views: 1,300,276
Posted By Danny B

It makes it faster...lol but seriously, it...

It makes it faster...lol

but seriously, it makes the spring a touch stiffer
Forum: Nitro Off-Road
02-24-2016, 11:49 AM
Replies: 4,255
Views: 1,300,276
Posted By Danny B

Would you rather I didn't post the complete...

Would you rather I didn't post the complete setup? it's like 15 minutes of work to make the mods. I for one would rather have ALL the little details. That's what makes a setup go, not just springs,...
Forum: Nitro Off-Road
02-24-2016, 10:55 AM
Replies: 4,255
Views: 1,300,276
Posted By Danny B

DNC Setup

DNC Setup
Forum: Nitro Off-Road
01-11-2016, 08:42 AM
Replies: 4,255
Views: 1,300,276
Posted By Danny B

If you choose the xray spring you want the XB8...

If you choose the xray spring you want the XB8 Spring, the Xb9 spring was junk.

Looks the only way to get the Xray spring is the complete servo saver assembly $37 and it's BO on Amain too...
...
Forum: Nitro Off-Road
01-06-2016, 02:05 PM
Replies: 4,255
Views: 1,300,276
Posted By Danny B

Been running the cars since October, I'd say I've...

Been running the cars since October, I'd say I've put them through their paces pretty well.

I've broken a few things but nothing that was unbelievably silly. I would consider them justifiable...
Forum: Nitro Off-Road
12-09-2015, 01:02 PM
Replies: 4,255
Views: 1,300,276
Posted By Danny B

Contact AE customer service. I believe the caps...

Contact AE customer service. I believe the caps are the issue. If you screw the cap on halfway and the cap will move up and down then you have the bad caps. If they've come loose several times ask...
Forum: Nitro Off-Road
12-03-2015, 10:47 AM
Replies: 2
Views: 645
Posted By Danny B

Strength. Plastic (Kit) servo arms for the...

Strength. Plastic (Kit) servo arms for the steering will strip fairly easily under the hard conditions of running 1/8. Use a Aluminum Clamping style servo arm for the steering. Most of the time, I...
Forum: Nitro Off-Road
11-24-2015, 08:02 AM
Replies: 4,255
Views: 1,300,276
Posted By Danny B

The key to getting your throttle to close...

The key to getting your throttle to close properly is the gap between the blue collar and the servo arm. you also need tension on the throttle rod spring. I felt the collar that came in kit was too...
Forum: Nitro Off-Road
11-12-2015, 04:47 PM
Replies: 4,255
Views: 1,300,276
Posted By Danny B

I've got a little over a gallon on my car and...

I've got a little over a gallon on my car and I've been extremely impressed with the wear on the drive line. The outdrives show no wear, the front/rear shaft pins virtually no wear, center drive...
Forum: Nitro Off-Road
11-12-2015, 04:40 PM
Replies: 4,255
Views: 1,300,276
Posted By Danny B

Something is jacked up with those springs, do you...

Something is jacked up with those springs, do you need to run M2C springs with their shoes? Looks like the springs with how they are sitting they are crazy stiff which would make the feeling of...
Forum: Nitro Off-Road
10-27-2015, 10:09 AM
Replies: 4,255
Views: 1,300,276
Posted By Danny B

The new tanks come with the springs pre-bent, But...

The new tanks come with the springs pre-bent, But I would still do the collar mod like this. 1/16" Collar(in the airplane stuff at LHS)
Forum: R/C Items: For Sale/Trade
10-06-2015, 12:41 PM
Replies: 7
Views: 578
Posted By Danny B

TTT

TTT
Forum: R/C Items: For Sale/Trade
10-02-2015, 10:41 AM
Replies: 7
Views: 578
Posted By Danny B

TTT Still available

TTT Still available
Forum: R/C Items: For Sale/Trade
09-29-2015, 08:11 AM
Replies: 7
Views: 578
Posted By Danny B

ttt

ttt
Showing results 1 to 25 of 500
 
Page 1 of 20
1
2
3
11
Last »


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.