LRP FlowX Firmware Updates
#1
LRP FlowX Firmware Updates
Noticed today that LRP have the firmware updates now available along with a USB bridge V3.
Does anyone know if the Spec 2 bridge used on the Flow series is compatible with the FlowX? It does state that the new V3 bridge can be used on the older Flow ESC.
Does anyone know if the Spec 2 bridge used on the Flow series is compatible with the FlowX? It does state that the new V3 bridge can be used on the older Flow ESC.
#2
You need the V3 bridge to connect to the FlowX. As you said it is downward compatible though and works with the older Flow controllers as well.
#3
Is that a new bridge? Or just firmware update for V2
#4
#5
Ok, where do you buy the V3 bridge from? I cannot locate it anywhere. #500904 is the part #
#6
Tech Champion
iTrader: (21)
#7
Tech Master
iTrader: (37)
Currently there are 3 updated firmwares for the Flow X, Flow X Offroad and Flow X Stock Spec esc range. All three esc are the same physically inside and have same ratings. The only differences are:
Flow X TC spec includes:
cooling fan for esc (30mm)
shortened rx wire
short set of fan screws
long set of fan screws
v4.1 firmware
Flow X Offroad includes:
longer rx wire
no fan included
long set of fan screws
v3.1 firmware
Flow X Stock Spec includes:
longer rx wire
no fan included
v5.1 firmware
All three updated firmwares (v 4.2, 3.2 and 5.2) only fix an issue with some motors and the sensor detection. (ie. blue led light stays on to indicate that there is an issue with the motor or sensor wire.)
To fix this issue, you can update the firmware to the above mentioned and available from the LRP website or you can just turn the motor over when or if it happens (ie. rotate pinion or spur gear until esc detects sensor position)
The new updated firmwares fix a bug in the original firmwares, but it is NOT required and it does not change or improve original firmwares.
Hope this helps and makes sense.
Thanks,
Leonard.
Flow X TC spec includes:
cooling fan for esc (30mm)
shortened rx wire
short set of fan screws
long set of fan screws
v4.1 firmware
Flow X Offroad includes:
longer rx wire
no fan included
long set of fan screws
v3.1 firmware
Flow X Stock Spec includes:
longer rx wire
no fan included
v5.1 firmware
All three updated firmwares (v 4.2, 3.2 and 5.2) only fix an issue with some motors and the sensor detection. (ie. blue led light stays on to indicate that there is an issue with the motor or sensor wire.)
To fix this issue, you can update the firmware to the above mentioned and available from the LRP website or you can just turn the motor over when or if it happens (ie. rotate pinion or spur gear until esc detects sensor position)
The new updated firmwares fix a bug in the original firmwares, but it is NOT required and it does not change or improve original firmwares.
Hope this helps and makes sense.
Thanks,
Leonard.
Last edited by DirtyDog3375; 10-10-2017 at 05:16 PM.