photopro123

iTrader: (7)

Hello everybody,

I just received an M11X with a 92744 receiver which I am trying to install in my Rustler. After I cut the tabs off the leads from the traxxas servos and plug them into the Airtronics receiver, there is no power and does not light up. Am I doing something wrong here? Any help much appreciated.

Thanks,

Joe

trigger

iTrader: (15)

Make sure you have the esc plugged into channel 2 and in the correct orientation. since you've cut the tab off he plug, you may have plugged it in backwards.

MontanaMaxx

iTrader: (12)

Make sure the signal wire is on inside I'm guessing that it is plugged in backwards also try binding it to your transmitter

dan_vector

iTrader: (27)

Have you gone through the binding process? The Rx won't light until it has been successful bound to the Tx

photopro123

iTrader: (7)

Thanks. Should it be channel two or should the lead from the esc go into throttle?

Thanks

photopro123

iTrader: (7)

Thanks. Is the binding process in the setup menu if the M11x? First you hit * then you hit enter?

Thanks

EbbTide

iTrader: (39)

I can't quite remember the steps for the m11x but if you Google search for the manual it should explain it thoroughly

MontanaMaxx

iTrader: (12)

To bind go to menu push * then while holding button down on receiver power on hold till flashes then press enter on transmitter should blink then go solid