So I have a cellpropower lab 6 and bought the protek RC parallel charging board to go with it and the wiring don't match up, so before I just randomly order another board what ones work with the pl6? I don't need the one from revolectrixs for $65. I'll only be charging 4 batteries at the most together.

You have to get the Power lab FMA balance board. It usues a JST-JP connector which is the only one that will plug into the charger.

EA

You can also change the connector on the balance cable of the Protek board to JST-PA.

OK I can do that just don't know where to get one. I've looked around just don't know what the right one would be. Do you have a link? Thanks.

http://www.progressiverc.com/ has all you need.

OK thanks so I should order this one then? http://www.progressiverc.com/fma-powerlab-8-balance-cable.html. I'll be looking for a new battery too so I'll check back here soon. Thanks again for all the input.

Yes, that should be the right one, you'll need a jst-xh connector to plug into the balance board, it looks like a 7wire is needed. Start from the black wire.

OK thanks, when It gets here I'll try to figure it out.