Got a question, I have a mamba max pro, and I am wanting to run a glitch buster with it, I bought a racers edge glitch buster that plugs into your receiver, but I only have a 3 channel receiver in this vehicle, and when I run the transponder all the spots are taken.

My question is, can I solder the positive and negative wires on the glitch buster to the positive and negative battery wires on the esc so that I don't have to plug it in? Will that work, or is that not how it works? Just curious, thanks..

No that's different, where the typical power cap goes. The glitch buster needs to go on the BEC side of the ESC. Usual solution is a Y servo harness, something like this:

Thanks. I think I answered my question, I was reading where you can supposedly plug the glitch busters into the bind spot on the receiver and that will work just fine. Then I would have enough spots open. I'll give that a shot, didn't even think about that.

Or the battery slot, that should work too.

Do you have a bind port free on the receiver? That should work....
EDIT: Ok, you found that out...good.

Thanks Dave. And Yosh.