Loosing signal problem
#1
Thread Starter
Tech Rookie
Joined: Aug 2013
Posts: 2
Hi I'm kinda new to rc an I was wondering if anyone might know what might be wrong. I have the dynamite revenge ecx type n. I just put brand new batteries in it an drove it for like an hour I had a minors crash an it stalled now the signal seems messed up. I'll push the throttle an it won't move at all no turning nothing. When I keep trying it'll go for like five seconds then go back to idle an just coast away. What might you think it might be the car is new havnt even gotten a gallon of fuel through it yet
#2
Assuming everything is mechanical okay on your vehicle, here is something to check...
- Fuel powered R/C vehicles still require electrical power to control the electronics (servos and receiver). It is possible after an hour of running that your RECEIVER BATTERY is dead or at low voltage. If the receiver battery is too low, it won't have enough voltage to operate the steering or throttle servos.
Let us know if you have already checked to see if the receiver battery is okay, or if it needed to be recharged.
- Fuel powered R/C vehicles still require electrical power to control the electronics (servos and receiver). It is possible after an hour of running that your RECEIVER BATTERY is dead or at low voltage. If the receiver battery is too low, it won't have enough voltage to operate the steering or throttle servos.
Let us know if you have already checked to see if the receiver battery is okay, or if it needed to be recharged.




