R/C Tech Forums - View Profile: IndyRC_Racer

Go Back  R/C Tech Forums > Members List
Reload this Page >

IndyRC_Racer's Profile

IndyRC_Racer IndyRC_Racer is offline

Tech Elite

About Me

  • About IndyRC_Racer
    Under-Employed Peon
    Country of Residence
  • Signature
    I'm currently racing onroad at Indy RC Raceway. https://indyrc.liverc.com/

    Check here for USVTA class rules/info: http://www.usvintagetransam.com/


Total Posts
Visitor Messages
General Information
  • Last Activity: 02-25-2024 07:25 PM
  • Join Date: 07-09-2006
  • Referrals: 0


Showing Friends 1 to 4 of 4

Visitor Messages

Showing Visitor Messages 1 to 1 of 1
  1. 10-18-2010 02:19 PM - permalink
    Hello. You were referred to me as a fellow that is running a TC3 in VTA with some success so I thought I would see if I could get some setup advice. I have been racing RC on and off road for several years so I am not completely without knowledge. I currently have a speedworks carbon fiber chassis with all the TC3 driveline. It seems like the other touring cars on rubber tend to push but I have the opposite loose in the rear condition, particularly when accelerating out of a corner. I currently have the car set up soft and with no swaybars. I have tried to tighten the front by stiffer springs only to have a push coming in and still loose going out. I know there are a huge amount of variables but would appreciate any pointers or setup advice that you could offer. Thanks in advance, Michael

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.