Greetings peeps,

As you might know this is my first post so I'm sure I'll feel welcome

You might have come across this Turnigy Servo tester (silver blue colour, 3 outputs, LED's impossible to look at because of brightness).

You might also know it has 3 modes (Manual, Neutral, Auto), in my case Neutral and Auto work like a charm....unfortunatley the manual function is not working no matter how far I turn the dial. I do get occasional jitters, but does not work as intended....I tried this on 5 different servos, Neutral and Auto work, just problem with Manual mode.

Any one else faced this?

Thanks and nice to meet you all

P.S: Yes I did also try to test a brushless motor using the brushless testing mode setup, same reaction...problem with the potentiometer perhaps?

Never mind guys, managed to bring it back to my local hobby store, they were awesome and happily replaced the item...I guess it was a faulty pot like I assumed.

CASE CLOSED
----------------------------------------------