Fly Sky FS-it4
Version 1.01-CN
03-06-2013
got it from: http://www.amazon.com/gp/product/B00...?ie=UTF8&psc=1

Acording to an email I got from flysky this confirms its the newest version. It said it was the titanium on amazon but I got orange not a big deal. trying to find out how to assign the switches now.

If I have to solder on a chip, it is not a big deal to me. I too feel sorry for those who do not have the soldering setups I do. Been a while since I have had to do chip replacement. I have not had any real solder wick for many years. I have just used flux and fine wire. Put some flux in my hand, work it into the wire strands and then twist. Makes a decent solder wick.

We will see.

Buzz.

Question. I'm charging via my computer, does it charge with the transmitter turned off and how do you know its full?

yes; and I just turn it on to check the voltage/charge indicator.

I am up for the challenge and if I cannot do it. I will go to see a friend who is an EE.

Have you tryed yet to bind multiple receiver's yet, just curious to see if it's been fixed.

Waiting on extra reciever.

Here is a snap of the chip:


It doesn't look too bad.

It looks like you have a one that will not bind to more than one model. Mine has the 1.01 and I just tryed to bind a second receiver and it would not do it.

The new boards look exactly the same and have the same Version number. Same firmware. Its something to do with the chip.

Made a vid - YouTube FS-iT4 vid

Nice. Thanks for putting that together. The music though?... eh. I had to mute it and unmute every once and a while to see if you were saying anything about the board or instal.

How long did it take to get the new board ?

@Blui3 OK I see they must be adding the new chip.

Is there a way to adjust the contrast on the screen? Its almost impossible to see in sunlight.