constant 6V BEC for 1S
 

Hi,

Can someone advise if the new Flow ESC support 6V BEC for 1S operation ?

Hello Luke

Do you still have those 13.5 thunder power settings? If so what would you change if you want to run 30d turning on the motor?

13.5 running an SXX V2 now going to run a Flow what can I expect.

Hello

In the same boat, I think much smoother power delivery, have you up dated to v5 software?

No. There is no booster. So for 1s you'll need to run a seperate booster or receiver pack.

Okie. :) thanks!

I've just read that the LRP Flow works team speedo 'ONLY' works with LRP, Nosram, Orion and Tekin motors! Is this correct??? as I have just ordered one.:confused::confused:

I'm using mine with a Reedy Sonic 10.5 and 13.5 if that's any good

No I haven't but will tonight. Just finished sons new car (he went with Viper) now I am starting mine LRP, Reedy, hope the Mach 2 come out quick.

so overall is this worth gettting?

What am I to expect in terms of performance and driveability switching to a flow works over a reventon pro??... Any issues?

I think a more correct description should be "any 540 sensored motor will work with the Flow Works team."

Hello

I don't think that's right, I will be running mine with a thunder power 13.5.
I have been running with Sxx 2 stock spec, with the up dated board and it will Defentley because up grade on that. And with v5 firmware it will at the cutting edge for stock.

I'm using mine with a Thunderpower 13.5T motor & a mate is using GM 13.5 T motor.

Hello

Do you have a good starting point to rub thunder power 13.5? I will also be running the new v5 firmware. Am running 6.4 gearing.