Lipo battery problem?
#1
Lipo battery problem?
I went to charge a 11.1v 2300mah lipo i use for my engine heater and the chager put a warning up saying the the balencer was not connected (it was) and battery voltage is too low, I know you cant run lipo's voltage too low, looks like I have. The question is have I killed this battery or is ther a fix?
#2
Tech Master
iTrader: (3)
May be able to be restored depending on how low you have taken it
Do the following ..........
Change charger mode to nimh
Connect pack with main leads only (no balance plug)
Set charge rate at 1 amp
Charge as a nimh pack and watch the screen
When pack voltage gets to 6.5v or so stop charger
Change to lipo mode
Plug in balance lead
Charge as normal
Cheers
Do the following ..........
Change charger mode to nimh
Connect pack with main leads only (no balance plug)
Set charge rate at 1 amp
Charge as a nimh pack and watch the screen
When pack voltage gets to 6.5v or so stop charger
Change to lipo mode
Plug in balance lead
Charge as normal
Cheers
#3
May be able to be restored depending on how low you have taken it
Do the following ..........
Change charger mode to nimh
Connect pack with main leads only (no balance plug)
Set charge rate at 1 amp
Charge as a nimh pack and watch the screen
When pack voltage gets to 6.5v or so stop charger
Change to lipo mode
Plug in balance lead
Charge as normal
Cheers
Do the following ..........
Change charger mode to nimh
Connect pack with main leads only (no balance plug)
Set charge rate at 1 amp
Charge as a nimh pack and watch the screen
When pack voltage gets to 6.5v or so stop charger
Change to lipo mode
Plug in balance lead
Charge as normal
Cheers
Next time I will check the voltage more often, I didnt realise my engine heater would discharge this battery so quickly, only got about two 15min heating out of this pack.