I need help, because I was told by a friend that all receivers can work with a LIPO Battery conected without a Voltage Regulator, what I have to ensure is that the servos I connect to the receiver are High Voltage servos.

If any one has a proper answer to this questions please your feedback will be much appreciated. At this moment I am running a Futaba 3PKs with a HRS 75Mhz receiver.

your rx can take it and it will not burn it out as long as you are running hv servos your good

Bringing this thread back from the vault...

Just curious if anybody else has had success running a R603FS at 7.4v with multiple high voltage servos?

I have been running this basic setup (KO 30101 steering and Savox 1268TG mech brakes both at 7.4v) for over two months now without any issues. I do use a CC BEC to make sure the Lipo voltage is regulated to 7.4v, but thus far the receiver seems to be handling the increased voltage.

all rx today can take up to 9 volts