Go Back  R/C Tech Forums > General Forums > Radio and Electronics
NEW HOBBYWING STOCK SUPERCHARGED SOFTWARE >

NEW HOBBYWING STOCK SUPERCHARGED SOFTWARE

Community
Wiki Posts
Search
Like Tree4Likes

NEW HOBBYWING STOCK SUPERCHARGED SOFTWARE

Thread Tools
 
Search this Thread
 
Old 03-03-2011, 11:56 AM
  #3511  
Tech Apprentice
 
Join Date: Jan 2009
Posts: 63
Default

Anyone know the ESC setting for 11.5T that team Hobbywing used to Win in TITC 2011? i have race on sunday, i hope i can use that seting for my race (i use HW Xerun 120A V2.1 and HW 11.5T motor)

Thanks
nietzbatik is offline  
Old 03-03-2011, 05:03 PM
  #3512  
Tech Addict
iTrader: (6)
 
Join Date: Jan 2008
Posts: 706
Trader Rating: 6 (100%+)
Default

Originally Posted by Tabushi
Guys,

If i have to race 8.5T (lipo 7.4v) touring class STOCK (no turbo, no timing allowed). Will the XTREME STOCK perform in the same way as XERUN 120amp ? ... or because of the higher "amp" of the 120amp (xtreme stock its 60amp), will be stronger ?

thanks,
As long as you have the same settings in the ESC they will perform almost identically. However, 8.5T is the limit of the Xtremestock. Personally I would run the 120A ESC. Just to be a on the safe side.

Shawn
Shawn68z is offline  
Old 03-03-2011, 05:37 PM
  #3513  
Tech Rookie
 
Join Date: Jun 2010
Location: Taiwan Tainan
Posts: 13
Default

Originally Posted by nietzbatik
Anyone know the ESC setting for 11.5T that team Hobbywing used to Win in TITC 2011? i have race on sunday, i hope i can use that seting for my race (i use HW Xerun 120A V2.1 and HW 11.5T motor)

Thanks
DRRS 9
Boost 36
Turbo slope 12
Turbo 24
Start RPM 3000
Delay 0.2
ACC 300
FDR 6.9
JoJiAuE is offline  
Old 03-03-2011, 08:09 PM
  #3514  
Tech Regular
 
fullout's Avatar
 
Join Date: Jan 2007
Location: mississauga
Posts: 316
Default cutting the red wire when using a 1s booster

I will be running my extreme stock in 1/12 on 1s and will be running a novak booster, do i cut the red wire from the speedo? And if i do does this affect the ability for it to be programmed via lcd programmer card?
fullout is offline  
Old 03-03-2011, 10:12 PM
  #3515  
Tech Addict
iTrader: (24)
 
Join Date: Oct 2009
Posts: 729
Trader Rating: 24 (100%+)
Default

When the 508 (no timing) firmware is flashed to the esc, does the LED in the esc flash orange all the time to indicate its got the no timing firmware on the esc?
rcuser67898578 is offline  
Old 03-03-2011, 10:23 PM
  #3516  
Tech Elite
iTrader: (5)
 
Bishop's Avatar
 
Join Date: May 2004
Location: Brisbane
Posts: 2,223
Trader Rating: 5 (100%+)
Default

Originally Posted by Johnny-RC
When the 508 (no timing) firmware is flashed to the esc, does the LED in the esc flash orange all the time to indicate its got the no timing firmware on the esc?
Well actually it flashes red, though I supose it can look a little orange if you have the blue case?, and it will not flash red all the time, just at idle, it turns solid red under throttle and green at full throttle.
Bishop is offline  
Old 03-03-2011, 10:32 PM
  #3517  
Tech Addict
iTrader: (24)
 
Join Date: Oct 2009
Posts: 729
Trader Rating: 24 (100%+)
Default

Originally Posted by Bishop
Well actually it flashes red, though I supose it can look a little orange if you have the blue case?, and it will not flash red all the time, just at idle, it turns solid red under throttle and green at full throttle.
Great I was hoping this was correct, and yes I do have the blue case Thanks for the confirmation.
rcuser67898578 is offline  
Old 03-04-2011, 03:41 AM
  #3518  
Tech Adept
 
Join Date: Apr 2010
Posts: 167
Default

Originally Posted by JoJiAuE
DRRS 9
Boost 36
Turbo slope 12
Turbo 24
Start RPM 3000
Delay 0.2
ACC 300
FDR 6.9

from rcfans -马达王 TITC 11.5组好盈电变设定
内齿比1.9 38-20 6.70齿轮比
0211 STOCK
启动模式 9,
进角 40
TURBO进角24
起始转速4000
换挡转速300
TURBO释放速度 18
延时0.2
任何设定都是需要符合当时的赛道和地面条件
这个设定可能对有些玩家来说是不够暴力的 但是对我来说是最舒服的 因为在15.9的最快单圈情况下最后几圈这个设定都可以做出16.1的单圈成绩
mos-leung is offline  
Old 03-04-2011, 04:28 AM
  #3519  
Tech Addict
iTrader: (1)
 
cherry2blost's Avatar
 
Join Date: Jan 2003
Location: London
Posts: 713
Trader Rating: 1 (100%+)
Default

Originally Posted by mos-leung
from rcfans -马达王 TITC 11.5组好盈电变设定
内齿比1.9 38-20 6.70齿轮比
0211 STOCK
启动模式 9,
进角 40
TURBO进角24
起始转速4000
换挡转速300
TURBO释放速度 18
延时0.2
任何设定都是需要符合当时的赛道和地面条件
这个设定可能对有些玩家来说是不够暴力的 但是对我来说是最舒服的 因为在15.9的最快单圈情况下最后几圈这个设定都可以做出16.1的单圈成绩
from rcfans - Wang TITC 11.5 motor power variable group set a good profit
6.70 gear ratio within the gear ratio of 1.9 38-20
0211 STOCK
Start Mode 9
Timing 40
TURBO into the corner of 24
Start Speed 4000
Shift speed 300
Release rate of 18 TURBO
Delay 0.2
Any settings are required to meet at the track and ground conditions
This setting may not be enough for some players, but the violence is most comfortable for me because the fastest lap in the 15.9 case, the last few laps this setting can make 16.1 lap

Thought I would do this first
cherry2blost is offline  
Old 03-04-2011, 05:56 AM
  #3520  
Tech Elite
iTrader: (15)
 
defcone's Avatar
 
Join Date: Feb 2009
Location: Sydney
Posts: 2,359
Trader Rating: 15 (100%+)
Default

Originally Posted by cherry2blost
from rcfans - Wang TITC 11.5 motor power variable group set a good profit
6.70 gear ratio within the gear ratio of 1.9 38-20
0211 STOCK
Start Mode 9
Timing 40
TURBO into the corner of 24
Start Speed 4000
Shift speed 300
Release rate of 18 TURBO
Delay 0.2
Any settings are required to meet at the track and ground conditions
This setting may not be enough for some players, but the violence is most comfortable for me because the fastest lap in the 15.9 case, the last few laps this setting can make 16.1 lap

Thought I would do this first
Did he win the 11.5t titc class?
defcone is offline  
Old 03-04-2011, 06:52 AM
  #3521  
Tech Addict
iTrader: (1)
 
cherry2blost's Avatar
 
Join Date: Jan 2003
Location: London
Posts: 713
Trader Rating: 1 (100%+)
Default Forms in Word.....

Can someone please help me out here, am trying to add editable fields into this form, have limited skills in Office so hope someone will be able to help me to add drop down boxes / click boxes to the empty fields in the Form.

Help !!!!!!!!

Cherry

Hope a genius can help out, i know what I am trying but it is beyond my capabilities I am afraid

Last edited by cherry2blost; 03-05-2011 at 01:08 AM.
cherry2blost is offline  
Old 03-04-2011, 06:58 AM
  #3522  
Tech Addict
iTrader: (1)
 
cherry2blost's Avatar
 
Join Date: Jan 2003
Location: London
Posts: 713
Trader Rating: 1 (100%+)
Default 0119 DL Link for those that can't find it on HW Site

Just for those that have asked here is the link to my hosted version, hope it helps

Download Hobbywing_USB_Link_setup_V1.63_110119.rar from FileFactory.com

Cherry
cherry2blost is offline  
Old 03-04-2011, 07:03 AM
  #3523  
Tech Apprentice
 
Join Date: Feb 2011
Posts: 72
Default

Angelo can we get try the latest firmware ?
flashrevolution is offline  
Old 03-04-2011, 07:05 AM
  #3524  
Tech Addict
iTrader: (1)
 
cherry2blost's Avatar
 
Join Date: Jan 2003
Location: London
Posts: 713
Trader Rating: 1 (100%+)
Default

Originally Posted by flashrevolution
Angelo can we get try the latest firmware ?
I wouldn't rush him as several people have complained about being used as 'Beta Testers' so let the Factory guys test it up to make sure it is perfect... Have patience Padwan
cherry2blost is offline  
Old 03-04-2011, 07:46 AM
  #3525  
Tech Rookie
 
Join Date: Mar 2011
Location: uk
Posts: 1
Default

is there any difference between the 2.0 & 2.1 versions of the esc
or are they the same thing?
andy o is offline  


Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.