lego project... which esc?
#1
lego project... which esc?
i dont know much about rc electronic so which esc should i get?
i am making a lego car and need it to be wireless so am using rc electronics. i have got a acoms techniplus receiver + servo
am looking for a esc to finish it of
must be under £20-25 pounds
and be brushed with bec
its for a 9v motor so should be 9.6v (or should i buy a 7.2v)
also should have reverse with or without brake
the lego motor draws 0.32 amps the the esc doesnt need to be powerful
i was thinking about getting helicopter esc because it cheap would that work on a rc lego car. it got acoms techniplus transmitter + receiver is that compatable or would i need separate radio gear. and do they have reverse
or should i just buy a proper rc car esc and which one, thanks
i am making a lego car and need it to be wireless so am using rc electronics. i have got a acoms techniplus receiver + servo
am looking for a esc to finish it of
must be under £20-25 pounds
and be brushed with bec
its for a 9v motor so should be 9.6v (or should i buy a 7.2v)
also should have reverse with or without brake
the lego motor draws 0.32 amps the the esc doesnt need to be powerful
i was thinking about getting helicopter esc because it cheap would that work on a rc lego car. it got acoms techniplus transmitter + receiver is that compatable or would i need separate radio gear. and do they have reverse
or should i just buy a proper rc car esc and which one, thanks
#2
Tech Master
iTrader: (22)
Airplane & Heli speed cons are great, but I would think lack reverse...
Any inexpensive car speed con. will likely fit the bill, but there would be voltage limits.
here is an example of about the cheepest fwd/rev I know of other than used.
http://www3.towerhobbies.com/cgi-bin...?&I=LXAMN7&P=0
You'll should check locally if you're not from this side of the pond.
Any inexpensive car speed con. will likely fit the bill, but there would be voltage limits.
here is an example of about the cheepest fwd/rev I know of other than used.
http://www3.towerhobbies.com/cgi-bin...?&I=LXAMN7&P=0
You'll should check locally if you're not from this side of the pond.
#3
yh im from UK so there aint many LHS, i been researching and i dont think there are many esc for that budget that fit the bill so i am going to start lookin got 6 cell esc instead, Thanks
#4
me and my buddy made rc cars out of k'nex a long time ago. we used standard car electronics though, servo, 6 cell battery, esc ad the motor was smaller than 540. maybe 300ish. i usually did dual motors. had decent speed and did wheelies. made front shocks. they actually held up pretty good. once i put a nitro engine in one but didnt work out so well.... the car broke apart while trying to pull start the engine. good luck with your project. its fun and different. i was going to try legos once but its too small for the electronics i was using.