I don't think this is true. You do know that you need to rebind the remote to the receiver to actually switch to hrs. If you bind your remote in normal mode then all digital servo's should work, then if you switch to hrs without rebinding, you are still technically in nor mode which all digital servo's should once again work in. I have a futaba 9551 digital low profile servo and it works no problem in normal mode and hrs without rebinding.

But if a rebind in hrs mode the servo will not function at all. So based on this it is my understanding that only a certain hand full of servo's will work in true sanwa/airtronics hrs mode.

And this was my question, is the PDS 2413ICS one the servo's that will work?

Recently purchased a M11x and I LOVE IT!!


Who makes an aluminum carrying case for it, and where do I get it?

Thanks

Ok, I did some testing last night and nothing solved the issue, When I pass the transponder over the loop off the track(unburied) it works fine has good signal so I believe the loop is just to low. My car counts fine at OCRC/WCRC but not revaluations.

run the 10amp external bec by castle to power your receiver! I also found running 1/8th electric esc makes the transponder a weaker signal!

I tried that, I know Novak made a transponder booster, My biddy has one gonna try that next.

Case
 

Since it seems that all cases are out of stock, anyone have another way/case to protect their radio?

For a case you can buy the Futaba 4PK case and you just cut a bit of the foam out and it fits perfect. You could also carry other items in your case if you wish as there is plenty of room.:nod:

you can "try" this one... it's generic. it has a lot of small squares you pull out to make your radio fit. looks good, but i can't vouch for it!

http://cgi.ebay.com/NEW-Hobbico-Cust...d#ht_626wt_698

Hey Mate check this link out http://www.rc-mushroom.com/product_i...ducts_id=18156 i bought one for my m11x and its perfect and the case has a carbonfibre look to it

That looks sweet but out of stock like all others.

Here's another one:

http://www.rc-mushroom.com/product_i...ducts_id=21176

Need Help
 

I have tried everything to include the manual. I am new to the M11X coming from DX3R.

Here it goes. I have one receiver and I bound it and named that TCX for model 1. That works great no issues. I have now installed another receiver in my VE8. I can not get the M11X to change from model 1 to model 2 so I can bind and start making adjustments. Top left continues to say m01:TCX. I can't get it to change to m02. What am I doing wrong?

Are you in Display mode ?

Yes it did say display mode only. What is that and how do I get out of display mode?

Amainhobbies carries the aluminum one that direct from Airtronics