R/C Tech Forums - Hudy Ultimate Engine Tool

Page 4 of 4

Show 40 post(s) from this thread on one page

R/C Tech Forums (https://www.rctech.net/forum/)

- Onroad Nitro Engine Zone (https://www.rctech.net/forum/onroad-nitro-engine-zone-71/)

- - Hudy Ultimate Engine Tool (https://www.rctech.net/forum/onroad-nitro-engine-zone/401724-hudy-ultimate-engine-tool.html)

Grinder

09-12-2011 05:56 AM

Quote:

Originally Posted by isokix (Post 9646787)

I am just about to upgrade my OS Speed XZ-R with ceramic bearings and I just wanted to check if these were the correct sizes from BOCA.

The sizes are:

Rear ID 14mm x OD 25.4mm x Width 6mm
Front: ID 7mm x OD 19mm x Width 6mm

I can't find in any manual or online the exact sizes to purchase..

http: // bit.ly/nIdApd

Those are the correct sizes.

ModeratedUser04102018

09-12-2011 06:07 AM

Quote:

Originally Posted by Grinder (Post 9646841)

Those are the correct sizes.

Thank you, I knew you someone on here would have the answer :))

lil-bump

09-05-2012 06:14 AM

Can anyone measure the front bearing catcher on the .21 bearing puller kit and tell me what the (.id) is. The .12 bearing kit will not pull a front bearing with an OD over 17.3 mm.

All times are GMT -7. It is currently 12:29 PM.

Page 4 of 4

« First

Show 40 post(s) from this thread on one page