Novarossi engines thread
#2746
Tech Elite
Novarossi takes 1,2,3 at the 2008 GLC. Using 359 motors.
DJ Apolaro
DJ Apolaro
#2747
#2748
novarossi sx12 turbo head factory carb settings
looking for factory carb settings
thanks for any information
thanks for any information
#2749
Tech Regular
Help..I Have a JP engine that is being tempermental. the bottom end will run intermitantly rich during a qual or a main, so we then have to lean the top end down to get it to run good and the temps are way high. i just agrrevating ill have it running real good pull in take a piss and then go back out and itll run fat on the bottom end
Hope it helps
#2750
I had have a jp B5t that was hard to set up like that
after 1 gallon or so, I mounted a non turbo head
and magic....
the engine was tuned immediately and
idled regularly too till now at 3 gallons
so perhaps it is not the carburator or o-rings
but a different turbo plug you need ..?
after 1 gallon or so, I mounted a non turbo head
and magic....
the engine was tuned immediately and
idled regularly too till now at 3 gallons
so perhaps it is not the carburator or o-rings
but a different turbo plug you need ..?
#2751
I have Plus21-3 7ports on road engine that I like to rebuild. I have changed the bearings and would like to change the piston liner and conrod as well. I just want to know if 35plus21 9ports or 359 9 ports piston liner and conrod can fit to my crankcase? If it fits will it make more power?
Thanks
Thanks
#2752
The 359 rod will not fit your crank.
35 +21 is almost the same motor. All parts should fit.
35 +21 is almost the same motor. All parts should fit.
#2754
What pipe would be recomended to be used on a 359 plus 2? On a more Bottom to mid range sorta track
I have a 2052 and a 2015. But only used on the 35plus found the 2052 was better but was told that 2015 made more power on dyno
I have a 2052 and a 2015. But only used on the 35plus found the 2052 was better but was told that 2015 made more power on dyno
#2756
Yeah i know i will with those 2. But they do make more then just those 2 pipes. Has anyone tried the others and had luck with them.
#2758
Nope no issue. None with my 35plus either maybe wrong fly wheel nut
#2759
...
did not like it, but not much choice.... others i asked did not need to do this . don't know why like that... couldn't possibly be they have different length crank shaft ??
#2760
Tech Apprentice
iTrader: (1)
hi, i had the same problem of not enough endplay with zero shims on my mtx4r clutch with my nova 353... had to put and add a small shim at the end of the crankshaft between the lock screw.
did not like it, but not much choice.... others i asked did not need to do this . don't know why like that... couldn't possibly be they have different length crank shaft ??