Novarossi engines thread
#1666
Yep the TZ is a good motor. If you liked the LL better aside from its slowdown in the middle you should try the LS tuned it has feels kinda like an LL that doesn't lose its snap around the shift point.
#1668
RX21R1WC conrod replacing
Hi guys,
Can anyone pls help me out... i think it's time to check for the conrod for replacement... the rod have not been change since new... how do u guys do the checking for replacement?? (i lost count of the usage cos i run 2 engines hehe...)
Can i use the R5 conrod instead of the R4?? cant find the R4 rod at my LHS...
thanks
ck
Can anyone pls help me out... i think it's time to check for the conrod for replacement... the rod have not been change since new... how do u guys do the checking for replacement?? (i lost count of the usage cos i run 2 engines hehe...)
Can i use the R5 conrod instead of the R4?? cant find the R4 rod at my LHS...
thanks
ck
#1669
Tech Rookie
run in..help
hi,everyone i just get myself a REX rer5p,now im runing in with 25%nitro...do i need to add a 0.1mm shim?coz one of my frend said is better to add a 0.1 shim but my pervious rb x12 i din add and also doing good....ok hope u guy can gave me some comment......tks
#1670
Tech Adept
Iv had both the LL3 and the LS3 and found the LS3 to be the better engine for me out of the two.
Ive also just run the MF 12 3P MasMo Version 2 and this thing is just another level and would be the best buy at the min.(see link)
http://www.mytsn.com/products/desc.asp?prid=4349
Ive also just run the MF 12 3P MasMo Version 2 and this thing is just another level and would be the best buy at the min.(see link)
http://www.mytsn.com/products/desc.asp?prid=4349
#1671
N12LS3
Guys,
I am running an N12LS3. The engine had no problem when the weather was hot. Now that it cooled down, I am having problems with the fine tuning.
When I start the engine, idle is fine. It pulls off without hesitation. Hit the top rpm on the straight or give full throttle in between and then come into the corner, it still wants to rev, the rpm doesn't drop immediately.
If I come to a full stop on the straight from high rpm, the rpm comes down but reaches a steady idle after let's say 5-10 sec.
Any suggestions where I should adjust?
I am running an N12LS3. The engine had no problem when the weather was hot. Now that it cooled down, I am having problems with the fine tuning.
When I start the engine, idle is fine. It pulls off without hesitation. Hit the top rpm on the straight or give full throttle in between and then come into the corner, it still wants to rev, the rpm doesn't drop immediately.
If I come to a full stop on the straight from high rpm, the rpm comes down but reaches a steady idle after let's say 5-10 sec.
Any suggestions where I should adjust?
#1673
Tech Adept
aaalp: The top end sounds too lean. The engine now needs some time to 'refill' with fuel after a full throttle burst and can't get enough fuel at its (still) high RPM to do so. If you go any leaner you will probably notice it making some sound as it starves for fuel on the straight.
The drop in RPM after idling for a while is related to this. Your bottom end adjustment probably is almost correct but takes a while to come into effect because the engine is still 'refilling'.
Try richening up the HSN by about 1/3th of a turn...
The drop in RPM after idling for a while is related to this. Your bottom end adjustment probably is almost correct but takes a while to come into effect because the engine is still 'refilling'.
Try richening up the HSN by about 1/3th of a turn...
#1674
i just looked at novarossi website, a bit confuse because of so many type of .12 engine.
just wondering, which one is the best for high speed track with 2 sweepers?
Novarossi Plus 12-3CT
just wondering, which one is the best for high speed track with 2 sweepers?
Novarossi Plus 12-3CT
Last edited by Xyvern; 09-26-2006 at 04:31 PM.
#1676
pls help with R01 WC conrod
Can i use the R5 conrod instead of the R4?? cant find the R4 rod at my LHS...
Anyone can input thanks...
ck
Anyone can input thanks...
ck
#1677
Tech Adept
I RECOMMEND THE NOVA 12-PLUS 3CT STOCK. MOD MOTOR MIGHT HAVE DIFFICULTY MAKING 5 MINS.
#1680
Tech Champion
iTrader: (3)
Originally Posted by ck960
Can i use the R5 conrod instead of the R4?? cant find the R4 rod at my LHS...
Anyone can input thanks...
ck
Anyone can input thanks...
ck