JL Racing .12
#1209
Tech Elite
iTrader: (74)
hey Sam,
is there anything special that I should know about changing the crankcase on an evo 3?I had a small crack in the tip/clutch end and it needed replacing, also i have noticed a small metal shaving on one of the ports on the piston is this ok as its just on the inner edge of the port?
thanks for your help
is there anything special that I should know about changing the crankcase on an evo 3?I had a small crack in the tip/clutch end and it needed replacing, also i have noticed a small metal shaving on one of the ports on the piston is this ok as its just on the inner edge of the port?
thanks for your help
Last edited by aussies1129; 02-20-2008 at 02:40 PM.
#1210
Can anybody help me with the part number of the crankcase for the JL EVO2. And where can i buy the crankcase from. And what is the factory setting for the carb. Thank you
#1211
Can anybody help me with the part number of the crankcase for the JL EVO2. And where can i buy the crankcase from. And what is the factory setting for the carb. Thank you
#1212
Can anybody help me with the part number of the crankcase for the JL EVO2. And where can i buy the crankcase from. And what is the factory setting for the carb. Thank you
#1213
Tech Champion
iTrader: (3)
hey Sam,
is there anything special that I should know about changing the crankcase on an evo 3?I had a small crack in the tip/clutch end and it needed replacing, also i have noticed a small metal shaving on one of the ports on the piston is this ok as its just on the inner edge of the port?
thanks for your help
is there anything special that I should know about changing the crankcase on an evo 3?I had a small crack in the tip/clutch end and it needed replacing, also i have noticed a small metal shaving on one of the ports on the piston is this ok as its just on the inner edge of the port?
thanks for your help
There is nothing special when changing crankcases, the JL2 and the JL EVO 3 had the same crankcase, I did not understand regarding your question about the metal shaving, on the piston ?