anyone know of a dealer in the us that seals the sirio pipe that was made for a the evo 3?

If you don't mind mail ordering... Hobby Bug Singapore has them.

Hobby Bug Singapore

how does the mugen seiki pipe perform with the sirio evo 3 .12?

Very nicely, the Skyline pipe is also very good with this engine.

Hello,

I need to order a couple of wrist pin clips for my EVO 3. My problem is that at the web shop the clips are in the section of .12 engines, but their part number is "s21-060010" (for .21 engines) instead of "s12-060012" wich I see as part number on the Sirio site.
will these clips fit?

Thanks in advance

hey where is the needle for idle setting in sirio evo2 ?

:confused: i got a sirio evo 3 engine running 20% at all times. I wonder if i changed to 30% , do i have to add extra shims on the head clearance? i have a factory shims, and i wonder, how much total clearance were the factory shims install in my evo3? .4? reply back, will appriciate it.

shimn pipe
 

Put a .1 shim in to make it .4 from .3.
This is good for 20 30 %. Stock is good for 16.
Also run a 7 or 8 sirio plug, it will kickass.
Thomas, the mugen pipe is not as good as the sirio evo 3 pipe.

cheers
Alex.K

hello,

I have a Sirio 12 tup 5 port engine. I broke the conrod twice. The second time I broke it just happened recently. How do I prevent this from happening? A friend of mine said that after 2-3 gallons of fuel you should replace the conrod. :D

Fritz

no worries man, i will use the siliooo pipe at the summernats, saves my super shiney muuuugen pipe from getting dented! :nod:

summer nats
 

Thomas enjoy the awsome Sirio power,
Ari will also be running one of my engines at the summer nats.

Which US distributor will be importing the SIrio motors, looks as if Trinity is no longer doing it from the looks on their website?

Kyosho USA will be the US distributor now. I think they are getting motors next week.

That's good news!

:eek: