how long does it take for just engine bearing replacements?

I can usually get them done next day if it is a rush. Otherwise I have been pretty swamped lately and it would take a couple days. Always let me know what engine you have so I can have the bearings on hand in case it is an odd size.

Rex

I am not going to be doing any motor work/modding the last week of April and first week of May. New engines will still be shipped if bought via e-mail or shopping cart on my site. Kendall my son will be handling that end but he doesn't do engine work.:)

Rex

Aw, com’on Rex, teach the boy to fish! :ha:

I will say my thread may not be entertaining but there is alot of good info here. I do need to clarify this for some that have asked. I feel like the best way to resurface the top of a sleeve for a better seal is using a machinist stone. I do this to every sleeve I touch, new or used. I do think chucking up a sleeve in a 3 jaw chuck is not a good idea. It could mark up the outside or even make the sleeve out of round if you tighten it too tight. A collett is a better way to hold it but using a lathe to resurface a sleeve will not be as flat as using a stone. The factory uses a grinder on the top of a sleeve.

Rex

Finally got my Scanner order, nice looking motors and servo's. I only bought 2 1/8 servo's to test, if it all works well I will get some in to sell.
The Scanner engines came with the Trackstar logo, these are similar but not the same as the other ones. First of all these have a Dlc crank, this is a clear coating similar to the newest Go GxII Ho. I also ordered them with Skf bearings and the 3 needle carb. Should be a great running motor, I will be Race prepping these before I sell them. I want to make sure the pinch is right and will do some other work. I am extremely busy so these will have to wait until May.

Rex

http://i424.photobucket.com/albums/p...r/img_6683.jpg

Thanks Rex for the super fast turn around on the pinch for me. Can't wait till the ground dries out to burn some nitro.

No problem Jason.
Like I posted earlier, I will not be able to do any engine work until after May 7th. If you need a new engine Kendall will get it shipped out for you, just purchase it in the cart.

Rex

Back from Vacation:tire::tire: I will be selling the Scanner engines for $115.00 "race prepped" they will be gone through and slightly modded.

Rex

Thank you for your time sir.

Dibbs

Did you tested the scanner engines??
What's the specs?

I have ran an engine very similar, it had the same internals. I am also planning on doing some testing with them soon.

Kendall and I will be at the JConcepts Spring Nationals in Omaha, if you are there stop by and say hi:)

Rex

Looks lije the old arrow

What is the current turn around time for an engine break-in? Also will it come back ready to race tune or will it need a little more run in?

congrats to Kendall at the Jcon race pretty stacked main