Kyosho v-one rrr
#646
Tech Rookie
I had some 3 racing parts but they din last too long..that was a huge disappointment..
#648
Tech Rookie
mtx-3 parts
i got two CVD sets and they din last..and some other parts too..
I heard SERPENT is selling their parts too..wondering if there's any improvement on their quality..
i got two CVD sets and they din last..and some other parts too..
I heard SERPENT is selling their parts too..wondering if there's any improvement on their quality..
#649
k-factory
are they any k-factory parts available for the the v-one RRR
#650
Re: Medial pro tyres
Originally posted by border r/c
do you mean these ?
http://shop.the-border.nl/customer/p...cat=600&page=1
do you mean these ?
http://shop.the-border.nl/customer/p...cat=600&page=1
#651
Tech Adept
how often do you guys change out the drive belts?
#652
Originally posted by rossiRocket
how often do you guys change out the drive belts?
how often do you guys change out the drive belts?
#653
BRCA 2005 rules
If you intend to race in the BRCA Nationals next year, the 2005 Rules Amendments for 235mm, Scale Rubber and 200mm Scale Touring classes is now available at 3hobby.com for download.
#654
Tech Adept
Originally posted by 3434
Kyosho VZW-025 (Ti) .2oz......... 7g but this only fits the R/RR. It is the same length as VZ-111
The 3Racing V1E-012 is drilled to accept the whole R line. R thru RRR
Kyosho VZW-025 (Ti) .2oz......... 7g but this only fits the R/RR. It is the same length as VZ-111
The 3Racing V1E-012 is drilled to accept the whole R line. R thru RRR
Just so i have this correct some of the middle shafts carry over to the rrr but not all? the vzw-025 does not fit? How about gearmain shafts? have they released any lightweight versions? And how about the first gear 1way holder...is there a lighter version of this too?
I ill check all those parts out. the midle shaft doesnt have a ton of stress on it so i think i will try the 3racing. torsional stress but no slamming into the boards stress like a cvd.
Thanks for the help.
#655
Tech Fanatic
anybody updated the rear sway bar to say a 2.5? does the one that comes with the kit work ok?
#656
Tech Adept
I dont know anyone where I race that has gone up sway bar stiffness. I just installed the silver lighter sway bar and am testing it this weekend. I know others who like the silver light bar.
#657
Tech Regular
The R & RR interchange and the EVO & RRR interchange. 3Racing drilled and added an e-clip ring so it works on all of them. (See picture) I have not seen a 3R yet just the manual. But the rear jack shaft is different on the 3R. As for the one-way FM-359 is the same in all of them and the 05R too. So you can use Kyosho TSW-15.
Last edited by 3434; 11-18-2004 at 07:52 PM.
#658
Originally posted by joemugen
anybody updated the rear sway bar to say a 2.5? does the one that comes with the kit work ok?
anybody updated the rear sway bar to say a 2.5? does the one that comes with the kit work ok?
#659
Tech Adept
thanks again 3434.
#660
TSW-15 Lightweight 1st gear housing