GMartinez

iTrader: (91)

If antyone has a link or company that makes a screw kit for the RRR please drop me a line I just finished building my first Kyosho car great kit but the screws got to go & no rcscrewzs they strip to easy looking for a titanium set.

jeffreylin

Square makes a great set SKV-51. Excelent quality but on the expensive side.

You can try getting it from Pro Shop Futaba ([email protected]) or Champ RC ([email protected]). Email them and they will quote you.

GMartinez

iTrader: (91)

Thanks for the Info

PhatPat

iTrader: (5)

http://rc-mushroom.com/product_info....oducts_id=6666

Dynamite

does anyone know where i can get the font that kyosho use as there logo?

Tim Johnson

http://www.fonts.com/

http://miniml.com/fonts/

http://www.typenow.net/themed.htm

Here are a few sources for fonts. Hope you find what you are looking for

wendellc1

I am having problems setting my car to have 200mm in the rear. The universals seem to be too short. Anything over 195mm will cause them to pop out. I am using fast tires 30mm in the rear. I've rechecked, I did install everything as instructed. Please help.

Thanks.

GMartinez

iTrader: (91)

Depending on the offset of the tire you can get the longer rear cvd's to reduce that issue.

jeffreylin

The WCE requires 2mm offset tires in the rear. If you still have the kit rear put them on and you'll see you have 199mm now in the rear. So your options are 1. use only 2mm offset rear tires; 2. use 2mm spacer between the wheel hex and rear 0 offset tires; 3. get VSW007 universals which is longer and then you can use 0 offset tires without spacer.

wendellc1

I did somewhat know the offset issue, but I tried using spacers to bring them out to 200mm. After using the spacers, the car couldn't handle. It got so nervous and wanting to spin out at hairpins. After I took the spacers off, everything is fine. Now, I have 200mm up front and 195mm in the rear. I want to invest in a set of CVDs, but will it do the same thing as the spacers? Thanks.

jeffreylin

Wider rear will give you more stability but you will have less side bite. You will need to change your setting to make it work. Actually, the kit setup will work well with the 199mm rear. Once you have it set up right it should work better than 200 front and 195 rear.

deviltires

i have the 11 steering in my car and i notice it doesnt turn in as sharp as i want it to on smaller tracks but i have not tried the 10

wendellc1

Thanks for the help.

Were you at last week's race at Revelation? There were a couple guys driving the RRR at the race.

XrayEye

iTrader: (1)

http://www.rcscrewz.com/

AndyT ©

I tried the titanium screws that rc-mushroom sell as a full RRR kit and they were rather poorly made to say the least