I have the mega picco engine but i got the wrong monoblock whic is for novarossi based. It looks fit.Can that make any problems?

Gokhan, hope it was helpful. Did you read Rene's comments below the article? Anyway, follow the instructions and no problems. I would change the rear to a 4 hole to start with.

Do the same as the rear one.

They are the same.

If it fits then no problems.

Yep it is ,thanks man also i found another helpful link http://www.mytsn.com/publ/publ.asp?pid=11441..

some parts are not the same... the front one comes with 2 clips + no plastic seal or the plastic washer that goes between the sleeve and then diff

It looks the same but when you screw them all up, the monoblock will tweak because the width between hole is different.

that's right, it is doesn't fit properly, there is going to be tweak for sure.

I'm not 100% sure but I believe the difference is in the placement of the screws that blot the engine to the block. I think in the beginning when we only had the Nova monoblock we drilled out the mounting holes in the engine block slightly to make the Mega fit on the Nova block....

Might be better to try and sell the block at the track or via Ebay and get the correct part...

Has anyone tried to mount an OS12 TZ to a monoblock? To which one?

Thanks!

I did and it doesn't work. I went back to the stock engine mounts.

dogbone pins
 

Does anyone know the size of the dogbone pins for a serpent 710?
My lhs sells the Hudy replacement pins but I need to know which to take.

3 x 9.7mm

BUT take a look at this http://3hobby.net/modules.php?name=E...ontent&tid=168 and click on the link at the bottom of that page. ;)

@Sow&Steady

Thanks for your advise!



By the way, I´ve just added a Mugen MRX-4 to my stable of race cars. Does anybody know where I can find a good forum (like this one for the S710) for my new speed machine? It´s pretty quiet in the Mugen thread here...

Thanks again!