I just finished installing the steering servo (sanwa) as per the manual and it all fits fine.
I did try a 1mm washer under the ball on the servo arm but changed my mind and just shaped the edge of the servo arm were it JUST touches the link. (not that big a deal):D

Look at www.sabahoceanic.com

They don't have it listed there but you can ask them to custom solder the config you want. You can send them an email but I doubt at the end of the day it would be cheaper with shipping and all... The actually have their office local here. So it is easy and cheap for us.:nod:

Re: Re: Re: MERRY CHRISTMAS
 

Thanks Roy ! Merry Christmas and Happy Holidays to you too.:nod: :D

Cool ! :nod: Enjoy ! :D

Re: Hudy Tyre Truer
 

Woow, that's serious man ! :nod: Hope you have fun with your new toy.:D

My apologies... I should have said that the shims I added was to clear the servo arms from rubbing the sides of the ballcups when the servo it at the end point for right side steering.

Perhaps you're right. I will take the shims out as it makes the linkage closer to the front belt. Don't see the need of the shims since I'm using shorter linkage now which does not make the steering servo travel far at the end point for right side steering which makes rubbing the servo horn with the ballcup linkage possible.

I got my 710 last thur. and im about 90% complete now, but I never had a carbon radio plate before, where can you mount the switch for the batt. and rec.?

Hi Guys

We got a couple of Serpent 710 left in stock and also Novamega 3 and 5 port turbo engiens as well. :)

Thanks

Steve Wang

There is no special place for the switch, you gotta find one yourself...:eek:
I attached mine at the throttle servo, so i can switch it on and off from the bottom of the car when my body is mounted...;)

MERRY CHRISTMAS!!!!http://www.funnyjunk.com/pages/sd2e.gif


Hope everyone got what they wanted for Christmas!!
I told Santa to tell the Easter Bunny to bring my 710!!:lol: :nod:


Happy Holidays and Happy New Year

In this case Easter Bunny will be dropping you a Rotten Egg :tire:

:sweat:

thanks Thaasman thats a good idea, Ill give it a try

ill contact them tomorrow.
thanks a lot man :)

Re: Re: Hudy Tyre Truer
 

Sure looking forward to trying it out D, now I just need some baseline settings to get me going for the Impulse Pro. I'm sure I read somewhere that the Jaco Nitro Shoes don't fit, is that correct and if so can anyone recommend a decent brand that works ?

Sorry for being slightly off topic. :)

Snakes!!
 

Ok!! We've put the engine and pipe and belt on the other car!! Going testing tomorrow! :)

http://www.trazz.com/rc/snakes2.jpg