MY MUGEN MBX6 BUILD
#18
whats up with the 1 pillow ball on the bottom of the knuckles.....looks like it has a collar of some sort ?
#20
#21
Tech Rookie
The kit looks really nice.
You may want to check your "diff out drive shaft/cups" as I see from the picture there are no grooves in them to retain the grease to stop them seizing up.
I think I read some ware this is a fault in the manufacture and they should have been supplied with the grooves.
You may want to make some enquires.
You may want to check your "diff out drive shaft/cups" as I see from the picture there are no grooves in them to retain the grease to stop them seizing up.
I think I read some ware this is a fault in the manufacture and they should have been supplied with the grooves.
You may want to make some enquires.
#22
REAR END - KIT BAG F
#23
thats kinda what i was thinkin.... goo moogen.
i also really like the center OD's Lots of holes for Lots of life....boots are nice also.
i also really like the center OD's Lots of holes for Lots of life....boots are nice also.
#24
KIT BAG G - MUD GUARDS !!!
#25
firstly thanks for taking the time to take so many pic's and upload them for us all to see, much appreciated
Looks like a real sweet ride very well made, a deffinate possibilty in my future
One thing, I don't think you've sealed the carbon components edges ?? Doing so will help protect them from delamination should you have an accident
If you have and I missed it sorry, not trying to pick faults just save you a few bucks bud. Thanks again for all the pic's
Rod
Looks like a real sweet ride very well made, a deffinate possibilty in my future
One thing, I don't think you've sealed the carbon components edges ?? Doing so will help protect them from delamination should you have an accident
If you have and I missed it sorry, not trying to pick faults just save you a few bucks bud. Thanks again for all the pic's
Rod
#27
firstly thanks for taking the time to take so many pic's and upload them for us all to see, much appreciated
Looks like a real sweet ride very well made, a deffinate possibilty in my future
One thing, I don't think you've sealed the carbon components edges ?? Doing so will help protect them from delamination should you have an accident
If you have and I missed it sorry, not trying to pick faults just save you a few bucks bud. Thanks again for all the pic's
Rod
Looks like a real sweet ride very well made, a deffinate possibilty in my future
One thing, I don't think you've sealed the carbon components edges ?? Doing so will help protect them from delamination should you have an accident
If you have and I missed it sorry, not trying to pick faults just save you a few bucks bud. Thanks again for all the pic's
Rod
#28
#29
did you notice the ackerman plate, ball studs not clearing the front upper arms at full droop?
#30