Looks great Overkill. Have you thought about adding some rc8t wider hubs?
A little extra width can really help keep it on its feet when you’re cruising at ridiculous speeds.

Quick question. After reading and going back and forth on trying to make up my mind on my next project

What are the absolute must have upgrades? Servo arm,steel center diff gear from what I’ve read are definitely on the top of the list.

What’s the largest motor that will fit? Since this truck is lighter in what I mess with a 4038 1700kv motor should fit or maybe a 4038 1550kv Tekin be enough?

You definitely need an aluminum servo arm. But the plastic spur gear is very durable. A steel spur is a nice upgrade but definitely not essential.

Yeah I’ve yet destroyed my mt4’s plastic gear so I can leave that off.

I got a airtronics rx/tx a Hitec 7050th and a sanwa servo Tekin gen3 rx8 and half set of trencher x’s that I was gonna use on other build

Is the truck about as big as the mt4? If so then I’m down

Also best deal to get one at? No local HS carriers in my area

It’s right about the same size as an MT4-g3. I can take a pic of the two side by side tomorrow. I got both my Tekno mt410 and et48.3 slightly used with extras on eBay and saved a few hundred dollars over new.

I’ll keep an eye out but I like building hence my lst projects lol

Thanks for your time and I’m sure I’ll have more questions after I buy one

Thanks. Yeah I've thought about it, we shall see.

Help, my buggy is too slow, what to do?

+ YouTube Video

Any luck contacting this guy? I'd like to up my order to four total sets of these.

The steering top plates are in production and I've got a large order of them coming to the US soon.

You da man Overkill!:)

Thanks for doing this Overkill!!

Do you have an active list or are you just going to post them when they are available?
Can I preorder?

Agreed with the above. Thank you very much.

Hope there is a Preorder

You'll know when I have them. No preorder.

Ok fellas heat update. I added a dynamite 1/8 motor fan and its beyond good now :) motor was at 112 degrees after 20 mins bashing on 17t so i went up to 18t and im gonna leave it there.