On-road @ TCHR
#151
Simons, the turnout has been pretty good lately.
#152
sponge, get your 12th sacle ready we should race them in a couple weeks
#153
I'm getting a new body ready as we speak.
#154
sponge, cool i'm getting a new car ready as we speak, no more sedan, no more buggy, maybe a 10th scale in the future, never know
#155
Tech Apprentice
Adam, why no more sedan? Too hard for ya? heh heh
I ran the B3 offroad again tonight, got a 29.8. I'm getting faster!
I ran the B3 offroad again tonight, got a 29.8. I'm getting faster!
#156
On-road info?
Curious on the on-road side when the Fall points series is expected to start. I'm getting the list ready and am looking forward to doing some foam stock/mod racing in preparation for the USTC races this year. Also, when will the "Fall" drivers meeting be held as well?
Later,
G
Later,
G
#157
Tech Apprentice
vink & sponge- I'm up for getting beat this weekend in 12th mod. Why no more buggy adam? what are you building? if its a 1oth pan, I'm pretty sure my brother would run with you...
#159
you are
#160
I just got home from work.
#163
u didnt hurt the driveway did ya?
#164
Tech Master
iTrader: (5)
nahh, didn't do that. Just threw it on the garage floor, grabbed a can of red spray paint, and made er red. I did put some silver window trim on with the airbrush. The tip keeps plugging up. I've tried thinning the paint, using more/less psi, more/less paint flow... it's good for about 30 seconds, then there's barely any spray. Maybe I just figured out why it was only $30.
#165
Tech Apprentice
JeffC, check out this forum for some airbrush tips- http://www.hobbytalk.com/bbs1/showth...threadid=11322
I have trouble with faskolor clogging up my tips as well. When I painted my B3 buggy, I didn't water down the paints but I did put almost full pressure from the pump. It sprays out like a bastard and I got decent results- I just had to be extra cautious when getting in closer to do edge shadows- and since I was using so much pressure I couldn't get them very thin, but it turned out ok and I didn't have to mess with the airbrush as much as I did the first time I tried painting with less pressure. . . It's still a pain though
Ben
I have trouble with faskolor clogging up my tips as well. When I painted my B3 buggy, I didn't water down the paints but I did put almost full pressure from the pump. It sprays out like a bastard and I got decent results- I just had to be extra cautious when getting in closer to do edge shadows- and since I was using so much pressure I couldn't get them very thin, but it turned out ok and I didn't have to mess with the airbrush as much as I did the first time I tried painting with less pressure. . . It's still a pain though
Ben