HK Talk Version 1.1
10-25-2001, 09:51 AM
#1501
They are Orion Motors!....... Orion make the motors for Hudy.... if look closely you will see the small label "made my Orion!"
10-26-2001, 06:57 AM
#1502
Originally posted by dtm
They are Orion Motors!....... Orion make the motors for Hudy.... if look closely you will see the small label "made my Orion!"
They are Orion Motors!....... Orion make the motors for Hudy.... if look closely you will see the small label "made my Orion!"
10-26-2001, 06:59 AM
#1503
Originally posted by Fire
you can use a cordless drill~
you can use a cordless drill~
10-26-2001, 12:44 PM
#1505
Originally posted by Disaster999
nono..its really hard to position the body for 1/12.....i have those dills!
nono..its really hard to position the body for 1/12.....i have those dills!
10-26-2001, 08:47 PM
#1508
Originally posted by Disaster999
i even trimed the body before i paint....i followed the grooves on thje body...but they dont fit the car....sigh...
i even trimed the body before i paint....i followed the grooves on thje body...but they dont fit the car....sigh...
When you mark out the positions for the holes, make sure the body is horizontal, mark and drill the two holes for the rear first, because these are usually higher and the posts will touch the body first. After drilling these holes, mount the body through these holes MAKE SURE THE BODY IS HORIZONTAL again and mark the front two holes out.
Are you having problems with getting the wheel arches to line up or the four posts to line up with the holes?
10-27-2001, 07:29 AM
#1509
999: go to HPI homepage there is a comprehensive guide on preparing a body.
10-27-2001, 06:25 PM
#1510
Originally posted by KY9fat
Drill B4 you paint.
Drill B4 you paint.
10-27-2001, 06:26 PM
#1511
Originally posted by Fire
you can use a cordless drill~
you can use a cordless drill~
10-27-2001, 06:27 PM
#1512
Originally posted by over gear
I've got shaft! I got FT TC3... 
I've got shaft!
I got FT TC3...
10-27-2001, 07:33 PM
#1513
DTM: well....im having problem lining up the wheels...like...when i trimmed the body, the front and rear wheels fit perfectly...but when i drilled the holes on the body, the front wheels fit...the rear are off, i think from now on, im going to trim the front wheels first, then trim the rear wheels when i have the body on....
10-27-2001, 07:39 PM
#1515
Originally posted by Disaster999
sigh...i bought a spray system yesterday, and bought some paint fro R/C bodies. the paint is from Pactra and it made a mess on the body!!
sigh...i bought a spray system yesterday, and bought some paint fro R/C bodies. the paint is from Pactra and it made a mess on the body!!