Motiv RC
|
|||
#706
Tech Regular
Anyone tested a 13.5 motor on a motolyer as of yet interested in trying one to see if it's better than my Orion for 1c use
Thanks
Thanks
#707
Suspended
I was hoping someone else with some knowledge of the Orion would chime in. My response will be a little biased of course, but I would bet the MC2 is a stronger motor. I don’t ever really recall hearing much buzz over Orion stuff in spec classes. I don’t have any motolyser numbers on a 13.5 MC2 to back up my thoughts.
#708
Suspended
New from Motiv, Defy Graphene series Lipos! Paul is releasing details on each new pack every day this week. So far we have the LCG 2s pack and the standard 2s pack:
MOV2018: 6000MAH, 2S, 100C, 7.6V, 45.6WH
Low CG
5mm Through Bullet
138.5mm Legnth X 46.5mm width X 22mm height
Weight: 273g
Best applications: Mod TC, Loose Track Mod Dirt oval
MOV1015: 8400 MAH, 2S, 100C, 7.6V, 63.8WH
5mm Through Bullet
137.5mm Length X 46.5mm width X 24.5mm height
Weight: 329G
Best applications: Stock TC, 4WD Shortcourse, Stock Dirt Oval,
MOV2018: 6000MAH, 2S, 100C, 7.6V, 45.6WH
Low CG
5mm Through Bullet
138.5mm Legnth X 46.5mm width X 22mm height
Weight: 273g
Best applications: Mod TC, Loose Track Mod Dirt oval
MOV1015: 8400 MAH, 2S, 100C, 7.6V, 63.8WH
5mm Through Bullet
137.5mm Length X 46.5mm width X 24.5mm height
Weight: 329G
Best applications: Stock TC, 4WD Shortcourse, Stock Dirt Oval,
Last edited by R Dodge; 10-13-2017 at 03:59 AM.
#709
New Motors?
Are there new motors in the works?
#710
Suspended
#711
MC3?
#712
From what I understood, Paul was waiting for the dust to settle on the new rules.
#713
Trying to help my buddy out who runs a Motiv motor. How do you guys set ampdraw back to the way he received it? The end bell and stuff came off and needs to get it back
#714
Tech Initiate
the MCR have the same performance and gearing of MC2 ?
#715
Suspended
Don't know, I don't think anyone in the states has tested the MCR because it is not ROAR approved. I doubt it is identical but I will ask Paul if you'd like. What class are you looking to run it in?
#716
Tech Initiate
yes, if you can ask Paul, i want run 13.5 blinky class , and i want more information about MCR , because in Motiv site not are information about the MCR
#717
Suspended
#718
Tech Initiate
touring class 1/10 outdoor medium/long track size
#719
Suspended
#720
The shaft is too long for my Awesomatix A800XA. It's hitting the battery unless I shim the motor out at least 1.5mm.
Can I trim the shaft without any ill effects on the motor?
Basically is that going to throw the balance of the rotor off?
Can I trim the shaft without any ill effects on the motor?
Basically is that going to throw the balance of the rotor off?