Is iCharger really superior?
#91
Tech Elite
iTrader: (71)
Just in case you were interested: http://www.tqracing.com/balance_&_power_cables.htm
Scroll to the bottom, item 2211.
Scroll to the bottom, item 2211.
#92
Just in case you were interested: http://www.tqracing.com/balance_&_power_cables.htm
Scroll to the bottom, item 2211.
Scroll to the bottom, item 2211.
TUH1170 - Pro Charge Lead Set
http://www.tuninghaus.com/accessories.html
Available at http://www.tqrcracing.com/shop/produ....asp?p_id=7830
#93
Or, Tuning Haus offers pre-made cables
TUH1170 - Pro Charge Lead Set
http://www.tuninghaus.com/accessories.html
Available at http://www.tqrcracing.com/shop/produ....asp?p_id=7830
TUH1170 - Pro Charge Lead Set
http://www.tuninghaus.com/accessories.html
Available at http://www.tqrcracing.com/shop/produ....asp?p_id=7830
#97
Tech Regular
iTrader: (5)
I wanted longer than Tuning Haus as well. I made my own using TQ 2211 balance connectors, Tuning Haus 4mm/5mm combo bullet connectors and 12g Novak silicone wire in 600mm lengths. I charge 2S at 40 amps and the wire is just warm. Works great! The cable wrap can be picked up at Frys for cheap along with the heat shrink.
#99
#100
Tech Elite
iTrader: (95)
Or, Tuning Haus offers pre-made cables
TUH1170 - Pro Charge Lead Set
http://www.tuninghaus.com/accessories.html
Available at http://www.tqrcracing.com/shop/produ....asp?p_id=7830
TUH1170 - Pro Charge Lead Set
http://www.tuninghaus.com/accessories.html
Available at http://www.tqrcracing.com/shop/produ....asp?p_id=7830
#101
Yes. However, even though the cable uses only a 3 wire plug, do NOT plug it into the three wire jack in the charger. That is the temp sensor port. You use the right hand most three pins of the larger jack, which is the balancing port. It helps to use a Xacto blade to cut the left hand nub on top of the connector off, so that it fits easier into the port on the charger.
#102
Tech Elite
iTrader: (95)
Yes. However, even though the cable uses only a 3 wire plug, do NOT plug it into the three wire jack in the charger. That is the temp sensor port. You use the right hand most three pins of the larger jack, which is the balancing port. It helps to use a Xacto blade to cut the left hand nub on top of the connector off, so that it fits easier into the port on the charger.
#104
Tech Elite
iTrader: (95)
Or, Tuning Haus offers pre-made cables
TUH1170 - Pro Charge Lead Set
http://www.tuninghaus.com/accessories.html
Available at http://www.tqrcracing.com/shop/produ....asp?p_id=7830
TUH1170 - Pro Charge Lead Set
http://www.tuninghaus.com/accessories.html
Available at http://www.tqrcracing.com/shop/produ....asp?p_id=7830
#105
For a 1s pack, the blue balancing wire goes in the 2mm tube on the red bullet plug, and the red wire just hangs free.