*NEW* WILDFIRE D06 Touring Car from VBC RACING
#1501
Tech Elite
iTrader: (66)
Got a race day in with the new towers. Car ran great. Need to get the long springs to get full use of the new tower though. But it really helped gain some up travel that I needed before. In the pics the forst is the new tower on top of the stock tower. In the second and third pics it shoes how much I had to run the spring up with stock and how far down with the Bezerk tower.
#1502
The towers look great. Bezerk makes good stuff.
#1505
I just installed the EMR 0 degree hubs on the back of my D06. These things are works of art. EMR i have a suggestion can you make suspension mounts that take the inserts from say AE (or spec R) that would fit the D06/7?
#1506
Hey all,
Anyone having problems with getting the same rear toe angle? left side getting 3 Deg and right 4 Deg, I can't seem to get them both equal? Any tips?
thanks heaps
Anyone having problems with getting the same rear toe angle? left side getting 3 Deg and right 4 Deg, I can't seem to get them both equal? Any tips?
thanks heaps
#1508
#1509
Tech Adept
I have the same problem with a brand new kit?
#1510
Tech Rookie
Raceberry shock towers
Hi, Dose anyone use Raceberry(3mm higher) shock towers for D06?
Someone said it is aimed for vbc shock+ long spring , the other hand
for Yokomo long shock (any other long shock) +long spring.
Is it possible to both with any modify?
Thank you.
Someone said it is aimed for vbc shock+ long spring , the other hand
for Yokomo long shock (any other long shock) +long spring.
Is it possible to both with any modify?
Thank you.
#1512
I have had this on every car I have owned, you just need to pinch it so you can get it as close as possible to the desired toe-in required
#1513
most likely the problem is in the rear hub. They could be bent a little. Try the EMR Factory aluminum rear hubs it should fix your problem.
#1514
I had the same issue with mine, I came to find out that when I put the bearings in the plastic hub I didn't have them straight in, they both angled a bit and threw the rear toe out (Mold flaw or my own mistake I don't know). I put the EMR hubs on and the bearings fit really snug and flat against the inner lip. My toe is exactly 3 degrees each side on my hudy station.
The plus side is the EMR hubs look awesome.
The plus side is the EMR hubs look awesome.
#1515
Has anyone ran the Smokem Racing 2mm chassis with Top Deck on a D06?